Featured in Feller Bunchers

Sort By:   GridGallery
Photo Title
Make Model Year Price
2004 Hydro Ax 570 Feller Buncher

2004 Hydro Ax 570 Feller Buncher

2004 Hydro Ax 570 with 22" sidecut 1 owner operator 4650 original hours. Has mostly new carbides newer skylight and front windshield 2 new front firestone tires 30Lx26 Joystick controls heat air heat grid quick couplers and 1 set babac bearpaw chains. Cummins 5.9 does not burn any oil and has zero hydraulic leaks. Very tight machine that was greased daily and well maintained. Ready to work, this buncher can lay down a lot of wood. Retired.

Hydro-Ax 570 22" Sidecut 2004
$70,000
Timbco T415-D Feller Buncher with a Quadco 20" 360 Head

Timbco T415-D Feller Buncher with a Quadco 20" 360 Head

2002 Timbco T415-D Feller Buncher with a Quadco 20" 360 Head. This equipment has a Cummins 8.3 engine. runs and starts good, new undercarriage, 24" single grouser. Newer Espar pre-heater, strong hydraulics and cylinders, tight controls, drive motor and pumps are in good working order, solid boom. Quadco 20" 360 has a straight blade no cracks, teeth are in good condition. Heat, A/C and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Timbco T415-D 2002
$80,000
Hydro-Ax 411 EX

Hydro-Ax 411 EX

Hydro-Ax 411 EX with Timbco bar saw head. Tires are 23.1x26 at 90-95%. 7000 hours. Clean machine in good condition.

Hydro-Ax 411 EX Unknown
$21,000
Hitachi EX150 with Timbco 22" Shear Head

Hitachi EX150 with Timbco 22" Shear Head

1996 Hitachi EX150 with a Timbco 22" Shear Head. Hour meter reads 7,000 hours, Isuzu 4 cylinder engine, runs and starts good, glow plugs, strong hydraulics and cylinders. Tight boom and head, this is a tight machine. Undercarriage is in very good condition, new rails, sprockets, and rollers, pads are in good working order. Dry valve bank. 22" Timbco shear head has sharp cutting edge, strong cylinders. Heat and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Hitachi EX150 1996
$32,500
CASE 1187C Feller Buncher

CASE 1187C Feller Buncher

1988 CASE 1187C Feller Buncher. This machine has a Cummins 8.3 engine, runs and starts good, 22" Rotto Saw Intermittent 40 degree tilt, newer undercarriage, tight pins and bushings. Runs good, hour meter reads 7,270 hours. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

CASE 1187C 1988
$24,900
Tigercat X822C Feller Buncher

Tigercat X822C Feller Buncher

2007 Tigercat X822C Feller Buncher. This equipment has a reman Cummins 2,590 hours ago, runs and starts good, new injection pump, new EGR, updated undercarriage to Tri-Link heavy duty 2,590 hours ago. New swing gear and newer final drives. Strong hydraulics and cylinders, most pumps were replaced. Tight boom and head. Tigercat 5400 continuous rotation head, pre heater, heat, A/C, and light. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Tigercat X822C 2007
$144,500
2008 John Deere 843J Feller Buncher

2008 John Deere 843J Feller Buncher

2008 JOHN DEERE 843J FELLER BUNCHER FD22B HEAD 6 CYL DEERE JOYSTICK STEER 28L-26 RUBBER WITH BEAR CLAW CHAINS ON FRONT

John Deere 843J 2008
$89,900
Hydro Ax 711EX Feller Buncher

Hydro Ax 711EX Feller Buncher

2000 Hydro Ax 711EX Wheeled Feller Buncher. This machine has a 8.1L John Deere engine that was rebuilt approximately 1,000-1,500 hours ago, 11,500 frame hours, new blade, new transfer case approximately 1,000-1,500 hours. Strong hydraulics and cylinders. Tight center section, cradles are in good working order, straight disc good teeth, 22" cut. 30.5 x 32 tires. Heat, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Hydro-Ax 711EX Unknown
$44,900
Valmet 425EXL Feller Buncher

Valmet 425EXL Feller Buncher

2008 Valmet 425EXL Feller Buncher with a 20" 40 Degree Quadco Head. This equipment has a Cummins 8.3 engine, runs and starts good, hour meter reads 11,800 hours. strong hydraulics and cylinders. Leveling system and swing bearing are in good condition. Both pumps have been replaced. Espar pre heater. Undercarriage is in good working order, 24" pads. Just went through some hoses and valve bank. Heat works, A/C needs a charge. LED lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Valmet 425EXL 2008
$112,500
Hydro Ax 470 Feller Buncher

Hydro Ax 470 Feller Buncher

2004 Hydro Ax 470 Feller Buncher. This equipment has a Cummins 6bt engine, runs and starts good, quick couplers. Strong hydraulics and cylinder. Joystick control. New injection pump, new hydrostat pump, transfer case was gone through, gear box was gone through. New disc. 28L x 26 tires 3 are @ 90%, 1 tire is @ 75% with a set of Bear Claw chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Hydro-Ax 470 2004
$45,500
Franklin 170 Feller Buncher with 20" Ronan Shear Head

Franklin 170 Feller Buncher with 20" Ronan Shear Head

1984 Franklin 170 Feller Buncher with 20" Ronan Shear Head.  This equipment has a Detroit 453 engine, starts & runs good, strong hydraulic and cylinders, few minor leaks, Head is in working order, 28Lx26 tires 20%.  Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Canada.

Franklin 170 1984
$12,000
Timbco 425 Feller Buncher

Timbco 425 Feller Buncher

1993 Timbco 425 Feller Buncher with a Shear & Extra Parts Head. This equipment has a 5.9 Cummins engine, runs and starts good, strong hydraulics and cylinders few minor leaks, tight boom, 20" head works as it should, new sprockets, 28" pads. Undercarriage is @ 60% quick couplers and block heater. Heat and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Timbco 425 1993
$34,500