2002 Timbco T415-D Feller Buncher with a Quadco 20" 360 Head. This equipment has a Cummins 8.3 engine. runs and starts good, new undercarriage, 24" single grouser. Newer Espar pre-heater, strong hydraulics and cylinders, tight controls, drive motor and pumps are in good working order, solid boom. Quadco 20" 360 has a straight blade no cracks, teeth are in good condition. Heat, A/C and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1996 Hitachi EX150 with a Timbco 22" Shear Head. Hour meter reads 7,000 hours, Isuzu 4 cylinder engine, runs and starts good, glow plugs, strong hydraulics and cylinders. Tight boom and head, this is a tight machine. Undercarriage is in very good condition, new rails, sprockets, and rollers, pads are in good working order. Dry valve bank. 22" Timbco shear head has sharp cutting edge, strong cylinders. Heat and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2007 Tigercat X822C Feller Buncher. This equipment has a reman Cummins 2,590 hours ago, runs and starts good, new injection pump, new EGR, updated undercarriage to Tri-Link heavy duty 2,590 hours ago. New swing gear and newer final drives. Strong hydraulics and cylinders, most pumps were replaced. Tight boom and head. Tigercat 5400 continuous rotation head, pre heater, heat, A/C, and light. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2000 Hydro Ax 711EX Wheeled Feller Buncher. This machine has a 8.1L John Deere engine that was rebuilt approximately 1,000-1,500 hours ago, 11,500 frame hours, new blade, new transfer case approximately 1,000-1,500 hours. Strong hydraulics and cylinders. Tight center section, cradles are in good working order, straight disc good teeth, 22" cut. 30.5 x 32 tires. Heat, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2004 Hydro Ax 470 Feller Buncher. This equipment has a Cummins 6bt engine, runs and starts good, quick couplers. Strong hydraulics and cylinder. Joystick control. New injection pump, new hydrostat pump, transfer case was gone through, gear box was gone through. New disc. 28L x 26 tires 3 are @ 90%, 1 tire is @ 75% with a set of Bear Claw chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1993 Timbco 425 Feller Buncher with a Shear & Extra Parts Head. This equipment has a 5.9 Cummins engine, runs and starts good, strong hydraulics and cylinders few minor leaks, tight boom, 20" head works as it should, new sprockets, 28" pads. Undercarriage is @ 60% quick couplers and block heater. Heat and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.