Featured in Logging Equipment

2008 Morbark 4600XL Wood Hog Horizontal Grinder. Hour meter reads 4,562 hours. CAT C3412, 760 HP Engine. Repairs completed at 3,280 hours. New Conveyor Belt, Rebuilt Hammermill including new bearings, rotor plates, rotor rods, hammers, inserts, and rakes. The machine is in good condition overall. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2008 CAT 501HD TRACKED HARVESTER 6 CYL CAT REBUILT ENGINE BY MICHIGAN CAT WITH WARRANTY FOUR ROLLER HEAD

2008 Morbark 30/36 Drum Chipper. This equipment currently has 4,120 hours, runs and starts good, strong hydraulics, drum and in-feed all are in good working order, maintained and run daily, complete maintenance and repair records available. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2008 John Deere 1270D Harvester. 11,000 hours. Recent new injectors in engine which runs and starts good. H480 head has been rebuilt. 2 outer drive motors and one inner motor were rebuilt recently. Espar engine, hydraulic, and cab preheat system, strong hydraulics and cylinders, reman work pump and drive pump in the last 500 hours, tight boom and center section, stick and lift cylinders redone, bogies are in good working order, solid rear ends, 700 tires @ 50% with rear tracks, one set of chains. Feed rollers and grab arms are in good condition, Timbermatic HHM 300 computer. Heat, A/C,and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2008 Ponsse Ergo Harvester with H7 Head. This equipment has a Mercedes engine, runs and starts good, strong hydraulics and cylinders, new conical pins in the crane base and upper and lower in the pillar. 6/20/18 all new pressure hoses, case drain hose and steal lines inside the boom. All new inner and outer swing gear bolts. bogies are in good order. Computer was just cleaned out at Ponsse. 710 tires are good with 1 set of tracks. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2008 CAT 501HD Harvester with Fabtek 4 Roller Head. Hour meter reads ~14,000 hours. CAT C6.6 engine starts and runs good. 24" single grouser pads. Undercarriage is estimated at 65%. Newer motor and pump with 600 hours. New ICAN computer. New chains on the feed wheel, also has new knives. Preheater. Enclosed cab has heat, A/C, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.