2005 Ponsse Ergo with Ponsse H73E Harvester Head. Hour meter reads 24,285 hours. Newer Opti 4G computer is integrated for GPS. Newer head pump input seal 150 hours ago. Heated seat. Boom and center are good. Lots of parts included, bars, chains, counter sensor, joystick buttons & switches. Like new tracks are available for an additional cost. Webasto preheat. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2018 Ponsse Ergo 8 Wheel Harvester with H7 Head. Hour meter reads 11,700 hours. 710/45-26.5 tires are estimated at 75%, includes a set of Olofsfors tracks estimated at 75%. H7 harvesting head is in good condition, C5 crane. Owner operator. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2002 Ponsse Ergo with Ponsse H73 Processing Head. Engine runs well. Machine has several cylinders, hoses and fittings leaking. 700/55-34 and 700/50-26.5 tires @ 30%. HN 125 Crane. Sheet metal fairly straight. Pins and bushings in decent condition. Machine is working and cutting wood. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2005 Ponsse Ergo Harvester with Ponsse H7 Head. Refurbished in 2014. Hour meter reads 13,158 hours. 710/45-26.5 tires are estimated at 50%, rears are estimated at 60%, includes a set of tracks and chains. Newer used bearing in the crane, new bushings where it pins to the frame. Ponsse rebuilt the gearbox for the crane, and rebuilt rear-end in the bogies less than a year ago. Clutch in the gearbox between the engine and clutch was replaced, with new seals in the hydraulic pumps. Webasto preheater. Comfort controls. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2022 Ponsse Ergo with H8 Harvesting Head. Hour meter reads 2,200 hours. 710/45-26.5 tires are estimated at 90%. Set of tracks are like new. Active frame, C5 crane, with H8 harvesting head. Lunch heater/cooler and AutoMat. Heat, A/C, radio, LED lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2008 Ponsse Ergo Harvester with H7 Head. This equipment has a Mercedes engine, runs and starts good, strong hydraulics and cylinders, new conical pins in the crane base and upper and lower in the pillar. 6/20/18 all new pressure hoses, case drain hose and steal lines inside the boom. All new inner and outer swing gear bolts. bogies are in good order. Computer was just cleaned out at Ponsse. 710 tires are good with 1 set of tracks. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.