This is a nice machine for the year, It has a Mercedes Benz 6 Cylinder Turbo Diesel Engine, Hydrostatic Transmission, 6x6, Differential Lock, Ponsse Dual Feed Drum Head, Continuous Rotator, Ponsse HN125 Crane, Extendable Boom, Hydraulic Crane Leveling, Articulate/Frame Steer, EROPS, Preheater, Heat, A/C, Radio, Opti Monitor, Ponsse OS We do take trades and we can assist with trucking and financing as well. Thank you for looking!!

2005 Ponsse Ergo Harvester with Ponsse H7 Head. Refurbished in 2014. Hour meter reads 13,158 hours. 710/45-26.5 tires are estimated at 50%, rears are estimated at 60%, includes a set of tracks and chains. Newer used bearing in the crane, new bushings where it pins to the frame. Ponsse rebuilt the gearbox for the crane, and rebuilt rear-end in the bogies less than a year ago. Clutch in the gearbox between the engine and clutch was replaced, with new seals in the hydraulic pumps. Webasto preheater. Comfort controls. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2005 Ergo factory refurbished in 2017, C4 crane, H7 head, new turbo and exhaust, main pump replaced last spring. Internal crane hoses replaced 6months ago, a set of chains for the big tire and a set of tracks @ 70%. good running machine just down sizing

2015 Ponsse Ergo 8 Wheel Harvester with H7 Head. Hour meter reads 4,767 original hours. Pre-emissions Mercedes engine. 710/45-26.5 tires are estimated at 40-60%. Includes two sets of tracks estimated at 25%. C5 crane is tight, H7 harvesting head is in good condition and working order. Hydraulic pumps were resealed within the last 100 hours, drive coupler replaced at 4,300 hours. Webasto preheater, heat, A/C, radio, LED lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

This machine has 18,826 hours on it, has Nokian Forest King tires, size 710/45-26.5 on the front, size 700/55-34 on rear. Machine has a Mercedes Benz engine, Ponsse H7 head, Webasto Preheater, Heat and ac, and an enclosed cab. We do take trades and we can assist with trucking and financing if needed. Thank you for looking!!

2010 Ponsse Ergo with 2015 Ponsse H7 Processing Head. Hour meter reads 23,257 hours. Mercedes engine starts and runs good. 710/55R34 tires on the front are estimated at 70%, 710/45-26.5 tires on the rear are estimated at 50%, includes a set of like new tracks at 90%. Webasto preheat and auto-grease systems. C4 crane. 2015 Ponsse H7 processing head that has been completely rebuilt besides the valving. Ponsse went through the machine in 2022. New swing motor, lift cylinders, pins, bushings, rotator, & hoses. Updated center section with frame lock cylinders. Heat, A/C, radio, comfort grip control and updated computer. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.