This is a very well maintained 1 Owner machine, It has just over 10K hours, Has single grouser pads, a preheater installed, and the Undercarriage is in good shape as well. There is a Waratah 622B processing head installed on the machine, that does have a topping saw on it. We do take trades and we can assist with trucking and financing as well, If needed. Thank you for looking!

John Deere 653E with Fabtek 4 Roller Harvesting Head. Hour meter reads 6,711 hours, owner states they are original. 24" double grouser pads, undercarriage is estimated at 65%. Fabtek 4 roller harvesting head is in good working order, has some welds, feed wheels and motor are in good condition. Heat, A/C, radio, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1993 John Deere 290 Processor with Fabtek Stroker Head. 24" triple grouser pads, undercarriage is estimated at 75%. Bar saw, stroker head is in good condition. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1998 John Deere 690ELC Processor with a Waratah HTH 20 622 Head. This equipment was just gone through approximately 3,000 hours ago, engine, hydraulic pumps and undercarriage. This processor has 16,500 frame hours, tight boom, head is in good working condition, new computer, swing gear is in good condition, heat, A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2000 JOHN DEERE 120 TRACKED HARVESTER 4 CYL DEERE FOUR ROLLER HEAD INDEPENDENT COUNTER

2005 John Deere 200C with Ryan's DS28 Dangle Head. Hour meter reads 12,000 hours. 24" single grouser pads, undercarriage is estimated at 75%. Ryan's DS28 dangle head is in good condition, 37" diameter capacity, 3/4 pitch. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.