Featured in Sawmill Equipment

1980s Desjardins Shingle Sawmill. Stored inside, 3 owners, very minimal use. Original paint on the machine, power unit was redone. Can be ran off 3 phase. Can separate the sawmill from the power unit if the potential buyer does not need the power unit, power unit is on the it's on frame. Has packing boxes, blowers, and some spare parts. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

WoodMaster 725 Planer. This planer has under 25 hours of use on it. Comes with 64 brand new knives of different formats. Has feed reverse switch & adjustable feed speed switch. Includes spiral head that has 164 separate 4 sided cutting knives on the head, a 725 Pro-Pak, and the 725 3 side molding system that uses 2 - 3.5 HP Milwaukee routers to enable operator to mold 3 sides of stock wood in 1 pass. Specs can be viewed on the WoodMaster website for planer and 725 Pro-Pak with 3 side molding system. Also includes a 5 HP Big Max dust collection system with 2 - 55 gallon barrels for collection of dust and shavings. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA.

Newman KF-24 Glue Line Gang Ripsaw. 75 HP Arbor Motor, 3600 RPM A/C electric motor. Glue joint cuts. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2012 Wood-Mizer LT35HD Sawmill. Hour meter reads 364 hours. 25hp gas engine. SimpleSet control system. Trailer kit with electric brake. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA.

Sprout Waldron Pellet Mill. This is a turnkey Pellet Making Operation. The grinder system includes a bin for loading shavings to feed the hammer mill. The hammer mill, feed conveyor, and auger in the feed bin are controlled with sensing units so that the mill cannot be over fed and jam up. As the amps on the hammer mill climb the feed auger slows, when the amps reach a pre-set limit the feed conveyor stops to allow the hammer mill to catch up. This is all 3 phase 240v components. The hammer mill has a ¼” screen, which is the correct size for the pellet system. It has a 40 HP motor. There is a small 220v blower which takes the feed stock out of the chamber, the hammer mill fills and feeds it into the hopper above the pellet mill. There is a 30’ out feed conveyor that the pellets fall onto out of the pellet mill, which also has a variable speed control and is reversible. There are misc. spare parts included. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Jackson Sawmill. Mill saw with cab, log deck, take away belts, green chains, 2 cut offs, and a homemade shavings mill. Includes 3 saws. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.