2012 Bandit 2590 Chipper. This chipper has a CAT C-15, 540 HP Engine, hour meter reads 4,633 hours and is still in use. Newer remote control kit, exhaust manifold, turbo, and clutch discs. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2018 Bandit 12XP Chipper with Winch. Hour meter reads 1,145 hours. PSI 3.0L 90 HP gas engine. 12" capacity and 24" drum, 14.25"x17" throat opening. Unit is in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2024 Bandit 15XP TK Track Chipper. Hour meter reads 1,300 hours. CAT 174hp engine. 37" diameter drum - 2 knife split pocket 5/8" chip. CAT 305 rubber track undercarriage is in good condition. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1994 Bandit 1400 Track Chipper. Hour meter reads 5,732 hours. John Deere 6076T engine starts and runs good. Undercarriage is in good condition, estimated at 60%. New turbo, injection pump, wiring, and lots of new hoses. Lever controls. Disc & knives are in good condition, new bearings & races, work ready. Cab, lever controls, heat. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2022 Bandit 19XPC Track Chipper. Hour meter reads 246 hours. John Deere 173hp diesel engine. Caterpillar 305CR rubber track undercarriage. 19" chipping capacity, includes remote control, with tether back-up. Drum is in good condition with 4 knives. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. ***ON HOLD***

2010 Bandit 3590XL Whole Tree Chipper. Hour meter shows ~6500 hours. CAT C27 1050 HP w/ optional engine chip to 1370 HP. Engine runs and starts good. Hydronic engine preheated. PT tech clutch. Extended frame, to offset radiator from the engine. Hydraulic reversing fan which increases HP to the chip drum. Upgraded feedbox wall plates to 2" AR 450. Chip pocket upgrades, overs breakers. Overs breaker grates upgrade that bolt in at drum chute. The following upgrades were made at 6,467 hours. New brakes and bearings, new top side of chute, new drum belly wear plate, new infeed chain sprockets, new manifolds and studs 6,467 hours. 36+ inch chipping capacity. Set up for .75" chip size, 2.75+ tons per minute capacity. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA