Featured in Bandit

Sort By:   GridGallery
Photo Title
Make Model Year Price
Bandit Intimidator 1590XP Brush Chipper ***SOLD***

Bandit Intimidator 1590XP Brush Chipper ***SOLD***

2012 Bandit Intimidator 1590XP Brush Chipper. Cummins C6.6 engine starts and runs good. Pre-DEF. No emission 18" infeed. Heavy duty axle frame. Auto feed & winch work as they should. Cutter wheel bearings were just replaced. Very minimal rust. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***

Bandit Intimidator 1590XP 2012
$65,000
Bandit 3590XL Whole Tree Chipper

Bandit 3590XL Whole Tree Chipper

2010 Bandit 3590XL Whole Tree Chipper. Hour meter shows ~6500 hours. CAT C27 1050 HP w/ optional engine chip to 1370 HP. Engine runs and starts good. Hydronic engine preheated. PT tech clutch. Extended frame, to offset radiator from the engine. Hydraulic reversing fan which increases HP to the chip drum. Upgraded feedbox wall plates to 2" AR 450. Chip pocket upgrades, overs breakers. Overs breaker grates upgrade that bolt in at drum chute. The following upgrades were made at 6,467 hours. New brakes and bearings, new top side of chute, new drum belly wear plate, new infeed chain sprockets, new manifolds and studs 6,467 hours. 36+ inch chipping capacity. Set up for .75" chip size, 2.75+ tons per minute capacity. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA

Bandit 3590XL 2010
$Call for Price
Bandit Model 2590 Chipper ***SOLD***

Bandit Model 2590 Chipper ***SOLD***

2012 Bandit Model 2590 Chipper. MTHis chipper has a CAT C15 540 HP engine, runs and starts good with 4,000 hours. Wireless Control, Auto-feed System, in-feed conveyor, hydraulic tongue tandem axle with air brakes. Ready for the woods. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

Bandit 2590 2012
$235,900
Bandit 280XP Chipper ***SOLD***

Bandit 280XP Chipper ***SOLD***

2006 Bandit 280XP Chipper. This machine has been completely refurbished in 2017 with a new CAT C4.4 engine, 183 hours, 18” capacity. Winch kit. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

Bandit 280XP 2006
$48,500
Bandit 1290 Chippers

Bandit 1290 Chippers

1993-1997 Bandit 1290 Chipper, 1 left. These chippers have new wheel bearings, rebuilt carburetors, alternators, and starters. Sandblasted and painted, new knives or re-sharpened, re-lined gas tanks, clutches as needed, new ignition cap rotor wires. They all have the Ford straight 6 300 cubic inch engine, run and start good. Contact Erik @ Red Pine Equipment 218-720-0933. Machines are located in Northeast USA.

Bandit 1290 1993
$9,500