Harvesters/Processors For Sale

2009 John Deere 703JH with Waratah 622B Processing Head. Hour meter reads 18,126 hours. John Deere 6081H engine. 24" single grouser pads, undercarriage is estimated at 65%. Espar preheat system. Suregrip joystick controls, heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2006 John Deere 703G Harvester. This equipment has 15,430 hours, runs and starts good, Waratah 616 processing head with top saw, newer bearings, 33' squirt boom, tight pins and bushings. Undercarriage is estimated at 50%, new tracks, strong hydraulics, swing gear is in good condition. One new final drive, all pumps have been gone through, new rear seal, and the main and stick cylinders have been rebuilt. Heat, A/C, and lights. Log-Rite system, touch screen update. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1998 John Deere 690ELC Processor with a Waratah HTH 20 622 Head. This equipment was just gone through approximately 3,000 hours ago, engine, hydraulic pumps and undercarriage. This processor has 16,500 frame hours, tight boom, head is in good working condition, new computer, swing gear is in good condition, heat, A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2001 Timberjack 608S Processor with 2005 Log Max 7000C Processing Head. Strong hydraulics and cylinders, ITR undercarriage has approximately 1,150 hours of use - rollers, sprockets and rails, 24" pads are in good shape. New pins and bushings in the boom 950 hours ago. 2005 Log Max 7000C is in very good condition, 5,960 hours, Logmate 402 computer, feed wheels and knives are in good shape, very little welding on head. Flex air reversible fan, Espar pre-heater system, heat, A/C, and LED lights. Machine is extremely straight and dry for it's age. All panels open and close as they should. No hydraulic leaks were visible. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

2010 Ecolog 590D with LogMax 7000 Dangle Head. Hour meter reads 17,813 hours. Mercedes 926 engine. 710/55-34 & 710/50-30.5 bogie tires are estimated at 75% or greater. Valve bank was just rebuilt, all new O-rings. Unit has some welding in the center and on the boom. LogMax 7000 dangle head, variable feed wheels, housing in good condition, pump is newer with 5,500 hours. Webasto preheat system, heat, A/C, radio, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2007 CAT 550 with FT180 Processing Head. Hour meter reads 11,902 hours. CAT C7 6cyl diesel engine & hydrostatic transmission. 700/45-26.5 tires are estimated at 50%, includes a set of tracks, 28Lx26 tires are estimated at 65%. Recently repacked cylinders in the FT180 processing head. New hydraulic pump has 400 hours on it. Newer saw motor, water pump, starter, joystick controls and cans. Rebuilt IQAN computer. Proheat preheat system. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***