1998 Timbco 415C Harvester with a Ponsse H73 Head. This equipment has a John Deere 6068T engine, runs and starts good, strong hydraulics and cylinders. Undercarraige is in good working order, single grouser pads. Ponsse H73 head is solid, grab arms and feed rollers are all in good working order, measuring system works as it should, Ponsse 1000 computer. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2018 Timberpro 725D Harvester with a 2013 Waratah 622B Harvester Head. Carrier has 1,600 hours, Cummins engine, runs and starts good, pre heat system, air ride and heated seat, backup camera, single grousers in excellent condition. Waratah 622B has approximately 9,000 hours, Timbermatic computer system. 24" pads, counter weights on tracks as well, heat, A/C, and LED lights. Warranty until 2,000 hours. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2009 Ponsse Ergo 6WD Harvester with a H7 Head. This equipment has 2,500 hours since a Ponsse reman was done, Mercedes Benz 6 cyl. engine, runs and starts good, pre-heat system, strong hydraulics and cylinders, bogies are in good working order, tight boom, squirt boom works as it should, solid boom base. Pumps are all in good working order, tight center section. Head and measuring system are in good working order, 710 tires with tracks, good glass. Heat, A/c, and LED lights. Contact Aaron @ Red Pine Equipment 218 -720-0933. Equipment is located in Northcentral USA.

2000 Ponsse HS10 Cobra Harvester with a Ponsse H60 Big Wheel Head. This equipment has an estimated 15,000 hours, CAT 3116 engine, runs and starts good, very clean for age. One set of tracks @ 50%, LoPro 700 Tires HN125 boom, strong hydraulics, tight boom, bogies are in good working condition. Pre heater, heat, A/C, and LED lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Woods ready processor. Being used on the job right now. Really good undercarriage. Runs really good. Very reliable machine. Could use some hoses. I replace them when they rupture. Roller measuring system. Pump done about 500 hours ago. Good glass. Good heat. Valve banks were resealed. Pretty straight for the year. 2 speed tracks works. Have a lot of spare bars to go with. Also have spare bar mount pieces and auto tensioner. Could use a few things on it. Would seriously consider trade for John Deere 440 cable skidder. Would seriously consider trade for firewood processor. Would seriously consider trade for small sawmill. Please call Derek at seven one five four zero nine zero seven zero seven with any questions. Thank you for looking

2013 TimberPro TL-725B Harvester with a Rolly II Head. Hour meter reads 7,500 hours, Cummins 8.3 engine, runs and starts good, 1,000 hours on a new pan gasket and main seal, flex plate was done at the same time, Espar pre heat system, fire suppression system. Strong hydraulics, new main pump 1,200 hours ago, drive pumps in good working order, new swing bearing and trunnion. Rolly II head has more hours then the machine but is in good working order, grab arms and both bottom and topping saw are in good working condition. Good glass, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.