2010 Bandit 3590XL Whole Tree Chipper. Hour meter shows ~6500 hours. CAT C27 1050 HP w/ optional engine chip to 1370 HP. Engine runs and starts good. Hydronic engine preheated. PT tech clutch. Extended frame, to offset radiator from the engine. Hydraulic reversing fan which increases HP to the chip drum. Upgraded feedbox wall plates to 2" AR 450. Chip pocket upgrades, overs breakers. Overs breaker grates upgrade that bolt in at drum chute. The following upgrades were made at 6,467 hours. New brakes and bearings, new top side of chute, new drum belly wear plate, new infeed chain sprockets, new manifolds and studs 6,467 hours. 36+ inch chipping capacity. Set up for .75" chip size, 2.75+ tons per minute capacity. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA

2011 Morbark 40/36 Drum Chipper. Hour meter reads 3,700 hours. CAT C18 engine starts and runs good. Advantage 3 drum is in good condition. 23" chipping capacity. 40"x39" infeed opening. Hydraulic knuckleboom loader with 23' extended boom reach. 2537 log grapple with 360° continuous rotation. Single grouser pads, undercarriage is estimated at 70%. Valve banks are dry and clean. Espar preheater. Enclosed cab has heat & A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***

2019 Altec DC1317 Chipper. Hour meter reads 325 hours. Kubota WG3800 gas engine, 3.8L 90hp. Unit is in good condition. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2019 Altec DC1317 Chipper. Hour meter reads 308 hours. Kubota WG3800 gas engine, 3.8L 90 HP. Unit is in good condition. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Custom Built Chipper. 23" diameter capacity. 380 HP Cummins with low hours on an overhaul. 3 knife. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1980 Morbark 22RXL Whole Tree Chipper. Engine was rebuilt 1,800 hours ago. Cummins 750 HP engine starts and runs good. Includes many extra knives. Feed chain is in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.