Featured in Logging Equipment

1999 Timberjack 1010B 6W Forwarder. Frame hours are unknown. Hour meter shows 23,000 hours, but is not working. Cummins 4BT engine starts and runs good. Double squirt boom. New center pins, line bored. 70/50-26.5 tires are estimated at 50%, the front two are agricultural tires and could be replaced. Heat, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

1999 Timberjack 1270B Harvester with a 762C Head. This unit has an International DT 466 engine, runs and starts good, preheat system, &strong hydraulics and cylinders. Pump and hydrostats are in good working order, joystick controls, one joystick has been recently rebuilt, tight boom, boom base has new bearings. 762C head and measuring system is in good condition, 26" bar, new end coder and diameter censor, also has 3 sets of feed rollers, peeling rollers, spiked rollers and rubber rollers. Good front glass installed recently. 600 tires with tracks and chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1999 Hyundai 130 Processor with a 2002 LogMax 750 Head. This equipment has a rebuilt head in 2015, brand new Cummins engine, runs and starts good, one year warranty on engine, 28" bar & chain, 26" cut, same as a 7000 LogMax, extra computer & feed rollers, undercarriage is @ 60%, strong hydraulics, tight boom, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1999 Barko 160D Truck Mounted on a Mack with s 60" Siiro Slasher. This equipment has an estimated 17,000 hours, 60" Siirro slasher table is in good working order. Rotobec grapple, Cummins 5.9 runs and starts good. Exhaust was just resealed, injectors were just resealed as well. Accumulator manifold was just resealed less then 200 hours ago. Pilot pump rebuilt 1,000 hours ago, right bank valve body rebuilt 1,500 hours ago. Swing pump rebuilt 1,500 hours ago, main pump was rebuilt 2,000 hours ago. Joystick controls. New LED lights. Heat. A/C is not working CB. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1999 Prentice 410E Loader, Ground Saw, and CTR Pull Through Delimber. This equipment has a Cummins engine, runs and starts good, strong hydraulics, tight joystick controls, tight boom, main cylinder was just rebuilt, continuous rotation grapple, Delimber and ground saw are in good working order, decent tires and brakes, heat, lights, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***ON HOLD***

1999 Fabtek 546B 6 Wheel Forwarder. Hour meter reads 7,399 hours. John Deere engine starts and runs good. 30.5x32 tires in the front estimated at 25%. 700 tires in the rear are estimated at 70%. Center and crane are tight. Heat, radio, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.