1998 Ponsse Cobra HS10 Harvester with a Ponsse H53 Head. This equipment has a Perkins 6 cylinder engine, runs and starts good, 6,500 hours on engine, new flex plate. Center cone bearing was recently redone, tight boom and grapple, double squirt boom extension in good working order, strong hydraulics and cylinders, tight bogies, few minor leaks. Ponsse 1000 computer, head is in working condition, may need a few pins and bushings. 700-45 x 22.5 tires @ 50%. Heat & lights. A/C will need some attention. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Canada.

2003 Timberjack 560D Dual Arch Grapple Skidder. 11,000 frame hours. 6,500 hours on new engine and transmission, both were replaced at 4,500 hours. Cummins 8.3L starts and runs good. 30.5x32 tires, rear tires estimated at 10%, front tires estimated at 30%, includes diamond ice chains. Heat, A/C, radio, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

1998 John Deere 690ELC Processor with a Waratah HTH 20 622 Head. This equipment was just gone through approximately 3,000 hours ago, engine, hydraulic pumps and undercarriage. This processor has 16,500 frame hours, tight boom, head is in good working condition, new computer, swing gear is in good condition, heat, A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2000 Tigercat 720C Feller Buncher. Hour meter reads 4,466 hours on a John Deere 6068 engine, runs and starts good. Hydraulic reversible fan, Webasto pre heat system, engine and hydraulic. Strong hydraulics and transmission, tight center section. Tigercat DW5000 Bunching Head, Firestone Forestry Specials 28L x 26 tires 16ply. Heat & A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1998-99 John Deere 748GII Dual Arch Grapple Skidder. This equipment has a Cummins 8.3 engine, runs and starts good, Power Shift transmission in good working condition, tight center, little play in arch pins, strong hydraulics and cylinders with few minor leaks, 35.5 tires @ 50% with dual rims. Trail blade with tilt. Heat and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1999 Timberjack 1270B Harvester with a 762C Head. This unit has an International DT 466 engine, runs and starts good, preheat system, &strong hydraulics and cylinders. Pump and hydrostats are in good working order, joystick controls, one joystick has been recently rebuilt, tight boom, boom base has new bearings. 762C head and measuring system is in good condition, 26" bar, new end coder and diameter censor, also has 3 sets of feed rollers, peeling rollers, spiked rollers and rubber rollers. Good front glass installed recently. 600 tires with tracks and chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.