2009 Prentice 2384 Loader with Bucksaw & CTR 426 Delimber. Hour meter reads 17,457 hours. Cummins engine starts and runs good. New compressor and bearing, no turntable slack. Bucksaw and CTR 426 delimber are in good working order. Joystick controls are tight. Kodiak Series 4 trailer has good tires and brakes. Heat, A/C, radio. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA.

2004 Prentice 384 Loader on Mack Truck. Hour meter reads 3,791 hours. John Deere 6059T engine. This unit was used in storm damage in Florida, has been mostly on pavement, the last 600 hours in the woods. Has a slasher hookup but has never been hooked up to a saw. Original grapple is tight. Dead heel. Mack truck is semi-roadworthy but mostly used in woods. No blowby but only used in shorter trips. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA.

2004 Prentice 280D Log Loader. This machine has a John Deere engine, runs and starts good, has been well maintained, strong hydraulics, tight boom and grapple, lower frame has been reinforced, tight control, Pitts carrier, good brakes and tires, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1999 Prentice 410E Loader, Ground Saw, and CTR Pull Through Delimber. This equipment has a Cummins engine, runs and starts good, strong hydraulics, tight joystick controls, tight boom, main cylinder was just rebuilt, continuous rotation grapple, Delimber and ground saw are in good working order, decent tires and brakes, heat, lights, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***ON HOLD***

1990 Prentice 180C Loader. Hours are unknown. Cummins 4BT reman engine starts and runs good. Boom and grapple are tight. Outriggers in good working order. Needs a few pieces of glass. Heat and A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1989 Prentice 210D Loader on 1989 Mack Truck. 183,397 miles on the truck, 12,573 hours on the loader. John Deere 6059T engine, & Eaton Fuller 10 speed transmission Bypass grapple with joystick controls. Oil pan is dry, cylinders overall pretty dry, oil lines are wet. 425/65 r22.5X8.25 Bridgestone tires. Tires are at about 80%. Red Dot aftermarket heater. Truck will be removed soon and loader will be placed on carrier if needed. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.