2009 Komatsu 220LC with Limmit 2100 Delimber. Hour meter reads 13,032 hours. New boom at 11,000 hours, and new cables & hoses at 12,800 hours. 32" triple grouser pads, undercarriage is estimated at 80%. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1998 Komatsu PC200 Delimber with a Risley 2000B Limit. This equipment runs and starts good, strong hydraulic and cylinders, straight boom, delimber is in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1999 Komatsu PC200 LC-6 with a ProPac 453 Delimber. Hour meter reads 20,000 hours. This equipment has a Komatsu engine, undercarriage is in fair condition but has never been changed, one owner. Has been a landing machine. Strong hydraulics and cylinders, pumps have been replaced, straight boom new 5,000 hours ago, new drive motor, new knives, tight pins and bushings, swing gear is in good working order, block heater, heat lights, A/C needs to be recharged. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1998 Komatsu PC200 with Limmit 2000B Delimber. Hour meter reads 10,800 hours. Komatsu ST5 engine. 32" triple grouser pads, undercarriage is estimated at 85%. Hydraulic pump was redone at 7,500 hours. 32" triple grouser pads, undercarriage is estimated at 85%. 1998 Limmit 2000B delimber, has a topping saw, will delimb a 24" log. Measuring system was purchased from Risley. Boom is straight. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2006 Komatsu PC200LC with a ProPac 513 Delimber. This equipment starts & runs good, strong hydraulics and cylinders, undercarriage is in good order, ProPac 513 has a straight boom, good cable and roller, knives and topping saw are in good condition. Heat, A/C, lights, and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1994 Komatsu PC250 Carrier with a Limmit 2200B Delimber. This equipment has a Komatsu 6 cyl. engine. Owner stated this machine ran good when it was parked but may need a tune up, engine has been rebuilt, strong hydraulics has a few leaks, undercarriage is @ 40%, 28" triple grouser pads, straight boom has been re-enforced in a few spots, decent knives and grab arms, swing lock has been bypassed may need a wiring harness. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.