2018 Morbark 40/36 Track Chipper. Hour meter reads 4,305 hours, new CAT C18 engine at 3,948 hours that has warranty. 24" double grouser pads, undercarriage is estimated at 90%. Advantage 3 drum chipper. Feed chain and drum are in good condition, minimal pitting, good knives. Wear-parts in the drum were updated, updated pockets. New belly pan and recent hard-facing on the drum. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2010 MORBARK 40/36 DRUM CHIPPER 6135 DEERE 600HP ONE OWNER HOURS WILL GO UP STILL IN USE JUST INSTALLED NEW DRUM AT 7278 HOURS

2011 Morbark 40/36 Drum Chipper. Hour meter reads 3,700 hours. CAT C18 engine starts and runs good. Advantage 3 drum is in good condition. 23" chipping capacity. 40"x39" infeed opening. Hydraulic knuckleboom loader with 23' extended boom reach. 2537 log grapple with 360° continuous rotation. Single grouser pads, undercarriage is estimated at 70%. Valve banks are dry and clean. Espar preheater. Enclosed cab has heat & A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***

1993 Morbark 30/36 WCL Whole Tree Chipper. CAT 325hp reman engine installed in 2009. Brand new wheels, brakes, and tires. All hydraulic lines including hard lines and valve body have been replaced this year. All 4 hydraulic pumps have been rebuilt this year. Onboard air compressor. LED work lights. All new belts, chains, and radiator. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2013 Morbark 2755 Flail Chiparvestor. Hour meter reads ~15,000 hours. CAT 27 875hp engine. 3 knife chipper disc option. Recently rebuilt gearbox and new spouts. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA.

1994 Morbark 23NCL Whole Tree Chipper. 850 HP CAT 3412 with 4,600 hours on in-frame overhaul. Top feed chute. Front of engine resealed. New drive belt and Poly chain. Does not burn any oil. Starts well in cold weather. Cooling system in good shape. Clutch in good shape. All new liners in 2021 on the chipper. Babbit 8 knife system installed. New remote system installed that controls all moving parts on the chipper. 8 knife disc is in good shape, set up for 7/8" chips. AR 450 face plates on disc less than 3 years old. New bearings on feed rollers, sprockets and chains recently replaced. Frame is in good shape. Air compressor included. Tires are in good shape and owner will check hubs and brakes at time of sale. Chipper was converted from a WCL, professionally done. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is lcoated in Canada.