2018 Tigercat 234B Loader with CSI 264 Delimber and CSI DL-4400 Bucksaw. Hour meter reads 4,395 hours. Loader is tight, 32' boom. CSI DL-4400 bucksaw has less than 300 hours on it, 264 delimber is in good working order. Trailer is in good condition, tires estimated at 30%. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2012 Serco 300 Self-Propelled Loader and 2001 Hanfab 72" Slasher. Hour meter reads 14,856 hours. 4,500 hours on newer engine, newer injectors with 1,000 hours. Front & rear ends were replaced in the last year. New webasto preheat system. Brakes and lights on the carrier are in good working order. 2001 Hanfab 72" Slasher has been gone through, no cracks or welds. Heat, A/C, radio, lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

2001 Serco 170A Loader with 60" Slasher. Hours meter reads 14,291 hours. John Deere engine. Boom is tight. 60" slasher included, blade and teeth are in good condition. Tires on the trailer are in good condition. Heat, radio, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1993 Serco 170 Loader with Siiro 60" Slasher. John Deere engine starts and runs good. Loader sits on a 1979 Mack truck that works well. Loader is tight, has a brand new main lift cylinder. Blade is straight, new teeth. Hydraulic landing gear works as it should. Heat in cab. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Serco 170A Loader on International 1900S with Lemco 60" Slasher. John Deere recon engine that was only ran in winter. New pump drive and main shafter bearing on the loader. Pump was recently resealed. Newer swing bearing. Outriggers in good working order. 30' boom with bypass bucket. International 1900S tandem axle truck, DT466 and clutch were just rebuilt. Lemco 60" slasher, blade reconditioned a year ago with 300 cords ran through since, newer teeth. Heat in cab. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

1980's International Load-Star Loader Truck with a 1990's Prentice 180D Loader and a 60" Siiro Slasher. This truck has a 671 Detroit engine, runs and starts good, 13 speed transmission. Prentice 180D Loader has a John Deere engine, runs and starts good, electric block heater. Joystick controls, tight boom and pins. Turn table is in good working order, newer swing motor, Barko 1/3 bypass bucket. Siiro Slasher has straight a blade and good teeth. Cab has heat and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***