2016 John Deere 2154D with Propac 453 Delimber. Hour meter reads 6,480 hours. Hydraulic overhaul at 4,000 hours. 24" double grouser pads, undercarriage is estimated at 90%. Propac 453, delimbing knives are in good condition, topping saw in working order. 2nd owner operator. Espar preheat system. Heat, A/C, radio, lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1998 Komatsu PC200 with Limmit 2000B Delimber. Hour meter reads 10,800 hours. Komatsu ST5 engine. 32" triple grouser pads, undercarriage is estimated at 85%. Hydraulic pump was redone at 7,500 hours. 32" triple grouser pads, undercarriage is estimated at 85%. 1998 Limmit 2000B delimber, has a topping saw, will delimb a 24" log. Measuring system was purchased from Risley. Boom is straight. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2005 Hyundai Robex 210LC-7 with Propac 453 Delimber. Hour meter reads 12,710 hours. Cummins 5.9 engine. This machine has a new boom as of 2019, some work has been done on the head, undercarriage is at about 60%. 28" triple grouser pads. Propac 453 Delimber works well. Straight, dry machine. Hours may increase because it's currently in use. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2005 Komatsu PC200-LC with a ProPac 453 Delimber and Circular Saw. This delimber has a Komatsu engine, runs and starts good strong hydraulics, decent undercarriage, straight boom, good cables, decent knives, straight saw blade, good teeth. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2014 Chambers Delimbinator. John Deere engine. Flail assemblies and floor are in good condition. Just serviced, bearings on the drum are good. Chains are in good condition. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1997 Link-Belt 2800 with 1998 Denharco DT3500 Delimber. This equipment runs and starts good, around 11,500 hours, strong hydraulics, cylinders and hoses are in order, straight boom and inner boom, knives are in good working condition, butt plate, undercarriage is @ 30%, heat. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.