1994 Komatsu PC250 Carrier with a Limmit 2200B Delimber. This equipment has a Komatsu 6 cyl. engine. Owner stated this machine ran good when it was parked but may need a tune up, engine has been rebuilt, strong hydraulics has a few leaks, undercarriage is @ 40%, 28" triple grouser pads, straight boom has been re-enforced in a few spots, decent knives and grab arms, swing lock has been bypassed may need a wiring harness. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1989 Komatsu PC200 LC-5 with a Denis D-3200-T Delimber. This equipment has a Komatsu engine, runs and starts good, Hour meter reads 10,594 hours, strong hydraulics and pumps. Straight boom and good cables, knives are in good working order, undercarriage is in good condition, 30" triple grouser pads. Chains and sprockets are in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1998 Komatsu PC200 with Limmit 2000B Delimber. Hour meter reads 10,800 hours. Komatsu ST5 engine. 32" triple grouser pads, undercarriage is estimated at 85%. Hydraulic pump was redone at 7,500 hours. 32" triple grouser pads, undercarriage is estimated at 85%. 1998 Limmit 2000B delimber, has a topping saw, will delimb a 24" log. Measuring system was purchased from Risley. Boom is straight. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2015 Volvo EC220DL with 2015 Propac 453 Delimber. Hour meter reads 12,410 hours. Volvo D6H 165hp engine. 28" triple grouser pads, undercarriage was just redone spring of 2022 & is estimated at 95%. Forestry package, heat, A/C, radio, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2014 Chambers Delimbinator. John Deere engine. Flail assemblies and floor are in good condition. Just serviced, bearings on the drum are good. Chains are in good condition. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1996 John Deere 690E with a Lim-mit 2000B Delimber. This equipment has a John Deere 6068T engine, runs and starts good, strong hydraulics and cylinders, boom cylinder is being rebuilt. drive motors and hoses in good working condition, U/C in good working order, 32" triple grouser pads. 2000B LIM-MIT delimber has straight boom, chains and roller in good working order, sharp knives, circular topping saw, Espar pre heat system, fuel heater, forestry guard package. Electronic idle will need work. Another 690E parts machine with a LIM-MIT delimber can be included. Heat, A/C, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Loader is located in Northcentral USA.