1996 CAT 322 with Denharco 3000 Delimber. Hour meter reads 14,300 hours. New engine and winch motor with 300 hours. Triple grouser pads, undercarriage is estimated at 50%. Denharco 3000 delimber is straight & in good working order. Topping saw. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Canada.

Pull Through Delimber. In good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Pull-Through Delimber. Knives are good. Mounted to a dual axle dolly. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1989 Linkbelt LS-2800 with a 1997 Limmitt 2000B Delimber. Isuzu 6cyl engine, runs and starts good, newer injectors. Straight boom, rollers and cables all in good order. Newer relief valves on the rollers & a new barrel for one of the lift cylinders. Re-packed right hand roller cylinder, new rubber bumper. Radiator was recently repaired and serviced, new windshield and some cab glass, new starter, temp gauge, & shutoff solenoid. Newer pump. Two new pressure relief valves. Heat in cab. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1994 Komatsu PC250 Carrier with a Limmit 2200B Delimber. This equipment has a Komatsu 6 cyl. engine. Owner stated this machine ran good when it was parked but may need a tune up, engine has been rebuilt, strong hydraulics has a few leaks, undercarriage is @ 40%, 28" triple grouser pads, straight boom has been re-enforced in a few spots, decent knives and grab arms, swing lock has been bypassed may need a wiring harness. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2000 Daewoo LL220 with Propac 453 Delimber. Hour meter reads 9,880 hours. New Daewoo engine and rotary motor for the hydraulics with less than 1,000 hours. 24" double grouser pads, undercarriage is estimated at 75%, new tracks pins & rollers, some new pads and hardware. Propac 453 delimber is in good condition, bushings were just replaced, boom is straight. Heat, A/C, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.