Forwarders For Sale

2003 Timberjack 1110D 8 Wheeled Forwarder. Hour meter reads 11,000, hours are around 20,000. John Deere 6068T engine. 700/45-26.5 tires are estimated at 75%. Frame locks have a little play but overall the machine is tight. Timbermatic computer system. Center was done 4 years ago. Espar preheat system. Heat, A/C, radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2001 Rottne Rapid SMV Forwarder. This machine has a newer John Deere 6068T engine with 2,000 hours, runs and starts good, strong hydraulics, newer drive pump, tight center section has been reinforced, boom is solid. New swing bearing in pedestal, grapple has a little play. One bogie has been replaced, 710 tires @ 50%, set of tracks, heat, radio and lights. A/C needs charge. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2001 Ponsse Bison 6 Wheel Double Bunk Forwarder. This equipment has a newer Mercedes Benz 4 cylinder engine with approximately 6,000-7,000 hours, runs and starts good. 13,000 total machine hours. New center pins and big bearing. New rear brake, new controller, strong hydraulics and cylinders. Tight boom and grapple. Heat, A/C, and lights. Tires are in good working order with a set of tracks. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***ON HOLD***

2000 Fabtek 546C 6 Wheel Double Bunk Forwarder. This machine has a 6.8 PowerTec engine, runs and starts good, rebuilt transmission and converter, Preheater. Strong hydraulics and cylinders, front tires are 30.5x32, tracks and chains, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2000 VALMET 646 DOUBLE BUNK FORWARDER 4 CYL CUMMINS POWERSHIFT JOYSTICK CONTROLS SQUIRT BOOM BYPASS BUCKET 700 HOURS ON NEW MOTOR

1999 Valmet 840 6 Wheeled Forwarder. Hour meter reads ~13,000 hours. This machine has a Sisu engine, extenda-boom, tracks and chains, good reliable forwarder, working daily. Major work done includes, valve bank re-seal, rear differential re-seal and brakes, new center oscillation bearings, main boom line bored, new pins and bushings, extenda-boom wear pads, radiator removed and chemical washed, starter and alternator, new A/C pump and expansion valve, new front tire, the rest are 60% or so, new water pump, grapple pins and bushings, new tracks. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.