Sort By:   GridGallery
Photo Title
Make Model Year Price
Hood S-182 Self Propelled Loader w/ Hood 60" Slasher

Hood S-182 Self Propelled Loader w/ Hood 60" Slasher

1985 Hood S-182 Self Propelled Loader with a Hood 60" Pull Behind Slasher. This equipment runs and starts good, strong hydraulics and cylinder, decent boom and 1/3 cord Bypass grapple, dead heal. Lever controls. Carrier and drive system are in working order. Slasher has a straight blade and decent teeth. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Hood S-182 1985
$19,900
International with Rotobec Loader and Siiro Slasher

International with Rotobec Loader and Siiro Slasher

1979 International with Rotobec Loader and Siiro Slasher. CAT 3802 engine starts and runs good. 15,000 miles on reman motor. 1,200 hours on the motor since the overhaul. Two brand new Vicker pumps, new input bearing, new pump drive, new suction lines. Rotobec continuous grapple, dead heel, lever controls. Siiro slasher saw motor and been rebuilt, includes an extra pump, new saw blade, two boxes of teeth, hydraulic cylinders, stroke slasher, and another complete saw ring. Also includes another tube, full chassis, bangboard, and extra knives. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Siiro - 1979
$22,000
CAT 579D Log Loader with CSI 4400 Slasher and CAT Delimber

CAT 579D Log Loader with CSI 4400 Slasher and CAT Delimber

2018 CAT 579D Log Loader with CSI 4400 Slasher and CAT Delimber. Hour meter reads 5,580 hours. CAT C4.4 engine starts and runs good. Loader is on a Pitts carrier. 32' maximum reach. Bucksaw table is 18' and in good condition, & CAT DLK426 Delimber has good knives with a 44" topping saw. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

CAT 579D 2018
$Call for Price
Hood 24000 Self Propelled Log Loader with Propac Slasher

Hood 24000 Self Propelled Log Loader with Propac Slasher

2004 Hood 24000 Self Propelled Log Loader with Propac Slasher. John Deere 6068 engine starts and runs good. Loader is on a Hagan carrier, with a Rotobec loader and Propac slasher saw. 28000 swing bearing. 2 hydro boards, set up for 4', 8', and bunks to 16'-6". Will cut up to 24' logs. Pilot controls. Heat. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

Hood 24000 2004
$72,500
Lemco 72" Slasher Table

Lemco 72" Slasher Table

1997 Lemco 72" Slasher Table. This equipment has a good strong pump, strong cylinders, straight blade, & decent teeth. Includes an extra axle and bearings. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Lemco 72" 1997
$14,500
Hood Loader with 60" Slasher

Hood Loader with 60" Slasher

1989 Hood Loader with 60" Slasher. 1500 hours on rebuilt 6.8L engine. Tight boom, slasher works as it should with strong hydraulics. Enclosed cab with lever controls. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Canada.

Hood - 1989
$29,900
Hanfab 72" Pull Behind Slasher

Hanfab 72" Pull Behind Slasher

Hanfab 72" Pull Behind Slasher. This equipment has a straight blade, good teeth with a few extras, solid frame, butt board is in good order. Good tires, pintle hitch. Contact Erik @ Red Pine Equipment 218-720-0933. Slasher is located in Northcentral USA.

Hanfab 72 Unknown
$12,500
Hanfab HF-60 Slasher

Hanfab HF-60 Slasher

Hanfab HF-60 Slasher. Has a straight blade, good teeth, solid frame, tires are at 80%. Push plate works as it should. Strong hydraulics and pump. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Hanfab HF-60 Unknown
$11,500
Tigercat 234 Log Loader with CSI 264 Delimber ***SOLD***

Tigercat 234 Log Loader with CSI 264 Delimber ***SOLD***

2009 Tigercat 234 Log Loader with CSI 264 Delimber. Hour meter reads 17,802 hours. Cummins engine starts and runs good. Hydraulic landing gear works as it should. Swing bear and pins and bushings are tight. Has hookup for a bucksaw, a CTR 52 model buck saw can be included for an additional $6,500. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southeast USA. ***SOLD***

Tigercat 234 2009
$Call for Price
Prentice 384 Loader with Riley 6600 Delimber & Topping Saw

Prentice 384 Loader with Riley 6600 Delimber & Topping Saw

2006 Prentice 384 Loader and a Riley 6600 Delimber with Topping Saw. Owner stated that this unit has no engine, Cummins 5.9 engine was removed. Entire fuel system has been replaced recently - 4 injectors, fuel pump, injection pump, transfer pump, injector lines and supply lines. Tight pins in boom, strong hydraulics, hydraulic pump has been replaced recently. Owner said that this loader is on a Kodiak trailer with hydraulic landing gear, joystick controls have been rebuilt. Owner said that this loader will need a new instrument panel or to be re-wired. Both the OEM and Cummins wire harnesses have been replaced from underneath cab to engine. All paperwork available on recent updates and repairs. Tires 60%, good brakes, Heat and A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine located in Southwest USA. is located in Southwest USA. REDUCED from 18,900.

Prentice 384 2006
$12,000
John Deere 437E Self Propelled Loader ***SOLD***

John Deere 437E Self Propelled Loader ***SOLD***

2018 John Deere 437E Self Propelled Loader with a 2018 Hanfab 6x6 Carrier, Rotobec 7606 360 Grapple, & Hanfab HF-72 Slasher. This equipment has a John Deere Tier IV engine, runs and starts good. Pre heat system. Hour meter reads 2,450 hours, some warranty remaining. Arctic Package, Aftermarket fuel filter heater. Strong hydraulics and cylinders, tight boom and grapple. Hanfab HF-72 Slasher, strong pump, very fast slasher. Cab has heat, A/C, LED lights, and radio. Hanfab self propelled 6x6 Carrier is in good working order. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

John Deere 437E 2018
$209,500
Lemco 7200 Slasher 72" Saw Table

Lemco 7200 Slasher 72" Saw Table

1998 Lemco 7200 Slasher 72" Saw Table. This equipment has a straight blade, teeth are in good order, hydraulic butt board, strong saw motor. Nice condition. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Lemco 7200 1998
$17,500