Harvesters/Processors For Sale

1991 Hahn HSW 110B Self Propelled Harvester. This equipment has a newer John Deere 6 cylinder 6068 engine with 2,500 hours, runs and starts good, strong hydraulics and cylinders, new hoses, few minor leaks. Newer heavy duty Case front axle, tight jib boom and grapple, will handle 8', 10', 12', 14', & 16' bang board and chains. Outriggers and log flipper are in good condition, stroke/delimber and knives are in good order. Cab has new heater, drive system is all in good order. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1999 Timberjack 1270B Harvester with a 762C Head. Per owner, this machine has a Navstar DT 466 engine that has been gone through, runs and starts good. Strong hydraulics, pump has been replaced. Boom and steer cylinders are in working condition. Head, CPU, and measuring system are in working order. New windshield. 710 tires, bogies and bearings are in good condition, tight center, pins and bushings have normal wear, engine pre-heater, heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2002 Timberjack 1270C Processor with a 762 Head. This machine has a Cummins engine, runs and starts good, 12,000 hours, strong hydraulics and transmission, solid boom base, squirt boom is in good working order, head has new hoses and knuckle. New pins and bearing on head. Timberjack 3000 TMC measuring system is in good working order, new wiring harness, solid bogies, 23.1 - 610 tires. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2004 John Deere 2054 Harvester with a Waratah 620B Head. This equipment has 14,500 frame hours. New motor has less than a 1,000 hours. Close to new approx. 95% rails, pads, front idlers, & sprockets. New hydraulic pumps 2,500 hours ago. New final drives 2,500 hours ago, rebuilt center joint 3,500 hours ago. All hydraulic hose and fittings are good. All boom cylinders are good. All controls work good, travel is good. The Waratah 620B head has same hours as machine, cylinders are all good, hydraulic hoses are all good, coupler fitting to boom at top of head is good, head rotate is good. Feed rollers are good, read outs good, 2 saws, Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northwest USA.

1998 John Deere 690ELC Processor with a Waratah HTH 20 622 Head. This equipment was just gone through approximately 3,000 hours ago, engine, hydraulic pumps and undercarriage. This processor has 16,500 frame hours, tight boom, head is in good working condition, new computer, swing gear is in good condition, heat, A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

2005 Ponsse Ergo Harvester with a H73E Harvesting Head. This machine has a Mercedes Benz engine, runs and starts good, 17,000 hours, pre-heat system, strong hydraulics and cylinders, new main pump at 13,500 hours, new joystick controls, old ones to go with as spares, tight boom, H200 crane, 710 tires with Eco track and a set of rear chains. Head and measuring system are in good working order. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA