Chippers For Sale

2022 Bandit 19XPC Track Chipper. Hour meter reads 246 hours. John Deere 173hp diesel engine. Caterpillar 305CR rubber track undercarriage. 19" chipping capacity, includes remote control, with tether back-up. Drum is in good condition with 4 knives. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. ***ON HOLD***

1992 Precision Husky Chipper. Hours are unknown. KT 600 HP engine starts and runs good. New batteries, oversized cables, master switch, oversized starter, pockets, knife clamps, and counter knives, digital volt meter, and re-cored radiator within the last year. New bearings in feed rear feed wheel, a few new sprockets, drive chains, drive motors for the top feed wheel, rebuilt injector pump, and new hydraulic pump belts within the last 8 months. Also has a new shaft and bearings on the bottom feed wheel. 23" throat. Will fill 42 ton in 30-40 minutes depending on the wood. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***

2011 Morbark 40/36 Drum Chipper. Hour meter reads 3,700 hours. CAT C18 engine starts and runs good. Advantage 3 drum is in good condition. 23" chipping capacity. 40"x39" infeed opening. Hydraulic knuckleboom loader with 23' extended boom reach. 2537 log grapple with 360° continuous rotation. Single grouser pads, undercarriage is estimated at 70%. Valve banks are dry and clean. Espar preheater. Enclosed cab has heat & A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***

2012 Morbark 2355 Flail Chiparvestor. Hour meter reads 17,000 hours. CAT C27 engine that was gone through a few years ago. 3 knife, liners are good, flails are in good condition. New PTO system in 2022. Needs new rubbers inside the flails. Includes spare bearings, conveyor chains, flail rods, & filters. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA.

1979 Morbark 22RXL Whole Tree Chipper. Full factory rebuild in 2004. CAT 3412, 800 HP engine. Twin disc clutch. Feed roller bearings, knives, & feed chains are in good condition. Produces 7/8" chips. 2014 Hood 8000 loader with Heat & A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2005 Bandit 280 Chipper with Grapple & Winch. Hour meter reads 1,300 hours on engine, 875 hours on auto feed. Newer 275 HP engine was installed. Includes extra knives, anvil, & bolts. Pintle hitch. Rated for 18" logs but can chip bigger. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast.