2010 Bandit 3590XL Whole Tree Chipper. Hour meter shows ~6500 hours. CAT C27 1050 HP w/ optional engine chip to 1370 HP. Engine runs and starts good. Hydronic engine preheated. PT tech clutch. Extended frame, to offset radiator from the engine. Hydraulic reversing fan which increases HP to the chip drum. Upgraded feedbox wall plates to 2" AR 450. Chip pocket upgrades, overs breakers. Overs breaker grates upgrade that bolt in at drum chute. The following upgrades were made at 6,467 hours. New brakes and bearings, new top side of chute, new drum belly wear plate, new infeed chain sprockets, new manifolds and studs 6,467 hours. 36+ inch chipping capacity. Set up for .75" chip size, 2.75+ tons per minute capacity. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA

1988 Kenworth T600 Loader Truck with a 1992 Prentice 210C Loader. This truck has a CAT 3406B engine, runs and starts good, 9 speed transmission. Loader has a rebuilt John Deere 6414, dragline controls, strong hydraulics and cylinders - few minor leaks, newer injection pump. Boom and grapple are in working order, dead heel. Heat & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2001 Rottne Rapid SMV Forwarder. This machine has a newer John Deere 6068T engine with 2,000 hours, runs and starts good, strong hydraulics, newer drive pump, tight center section has been reinforced, boom is solid. New swing bearing in pedestal, grapple has a little play. One bogie has been replaced, 710 tires @ 50%, set of tracks, heat, radio and lights. A/C needs charge. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2006 Ponsse Wisent 8 Wheel Double Bunk Forwarder. This machine has a Mercedes Benz engine, runs and starts good, Pro Heat, new transmission last year installed by Ponsse, new rear-end installed last fall, bogies are in good working order, tight boom and grapple, squirt boom works as it should, decent 710 tires, blade. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2014 John Deere 748H Dual Arch Grapple Skidder with Winch. This equipment has 9,050 hours, John Deere 6.7 engine, runs and starts good, direct drive with manual option, newer hydraulic pump, tight center section, arch and grapple are tight as well. Solid axles and cradles. Strong winch. 73 x 44.00- 32 tires, 2 new rears front tires @ 50%, dual rims. Heat, A/C, and lights. Well maintained. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2001 CAT 311 Harvester with a Fabtek 4 Roller Head. This machine has a new CAT engine, runs and starts good, strong hydraulics and cylinders, newer undercarriage with 2,500 hours, 22" pads, tight boom. Fabtek 4 roller head has new spikes on rollers, new chains, grab arms and hoses are in good working order, Upton computer, 33" Jet fit bar. Heat, A/C, and lights, air ride seat, good glass, quick couplers. Forestry Package. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.