Sort By:   GridGallery
Photo Title
Make Model Year Price
Morbark 30RXL Chipper  ***SOLD***

Morbark 30RXL Chipper ***SOLD***

2003 Morbark 30RXL Chipper. This machine runs and starts good, strong hydraulics, wireless remote control with tethered backup, 30” x 10’ CAT chain infeed bed (RXL ). 30” diameter chipping capacity, 83” diameter three-knife chipper disc with LH rotation, loader with cab, chipper is in good working condition. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine located in Canada. ***SOLD***

Morbark 30RXL 2003
$126,500
(2) John Deere 748H Skidders  ***SOLD***

(2) John Deere 748H Skidders ***SOLD***

(2) 2010 John Deere 748H D/A Grapple Skidders. These skidders run and start good, tires and chains are @ 50%, 30.5 X 32, strong hydraulics, tight pins and bushings, heat A/C, and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada. ***SOLD***

John Deere 748H 2010
$94,000
John Deere 2054 Processor  ***SOLD***

John Deere 2054 Processor ***SOLD***

2006 John Deere 2054 Processor with Waratah HTH 616 Head. This machine has a 6068T Teir II engine, runs and starts good, has been well maintained, undercarriage is in good working condition, tight boom, Waratah HTH 616 head is tight, strong hydraulics, heat, A/C, and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada. ***SOLD***

John Deere 2054 2006
$107,500
Morbark 2755 3 Flail Chipper  ***SOLD***

Morbark 2755 3 Flail Chipper ***SOLD***

2008 Morbark 2755 3 Flail Chipper. This machine has a CAT C27 875 HP engine runs and starts good, engine was overhauled Sept. 2013, Flail engine C13 440 HP, runs and starts good, tight boom, everything is in good working condition, chipper is on job site now. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada. ***SOLD***

Morbark 2755 2008
$499,900
CAT 525C Skidder

CAT 525C Skidder

2006 CAT 525C D/A Grapple Skidder with Winch. This skidder has 11,750 hours, runs and starts good, new center section less then 500 hours ago, strong hydraulics and transmission, new glass, winch in good working condition, new A/C compressor, tires are 30.5x32 @ 40-50%, chains on front, good cable. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA.

CAT 525C 2006
$74,900
Prentice 2344 Forwarder

Prentice 2344 Forwarder

2007 Prentice 2344 Forwarder. This machine has 9,000 hours, Cummins 4 cyl. engine, runs and starts good, tight pins and bushings, pretty tight center, tight boom and Sure Grip Grapple, strong hydraulics and auto transmission, extended bunks, 3' to haul 12' logs, 23.1x26 tires @ 75%, heat, and A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***REDUCED FROM $105,500.00***

Prentice 2344 2007
$90,000
Rottne SMV Rapid EGS Harvester ***SOLD***

Rottne SMV Rapid EGS Harvester ***SOLD***

2000 Rottne SMV Rapid EGS Harvester. This machine has ~15,000 hours, RK200 boom with table tilt cylinders rebuilt and re-chromed, 2 other boom cylinders rebuilt also. Main hydraulic control valve resealed, new hydraulic pump, new starter, new heater motors, new water pump, injectors rebuilt, has a John Deere 6 cylinder motor, Logmax 5000 head on it with 1 new cable from boom joint to head, new saw bearing, all cylinders either rebuilt or new, new measuring wheel arm bushings, bearings and measuring sensor for length, and Hultdins combination tracks for back bogies. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Canada. ***SOLD***

Rottne SMV Rapid 2000
$Call for Price
Rottne SMV 8 Wheel Drive Log Forwarder ***SOLD***

Rottne SMV 8 Wheel Drive Log Forwarder ***SOLD***

1999 Rottne SMV 8 Wheel Drive Log Forwarder. This machine has a Ford 6 cyl engine, hydrostatic drive, 4 bunks that have been widened by 6" on each side and stakes made to swivel, RK90 loader with Super Grip 360 grapple, all cylinders have been rebuilt, hydraulic pump rebuilt 1,500 hours ago, 2 sets of snow-rock tracks, spare tire, parts, and service manuals. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada. ***SOLD***

Rottne SMV 1999
$90,000
Tigercat L830 Feller Buncher

Tigercat L830 Feller Buncher

2003 Tigercat L830 Feller Buncher. This machine has 5,300 on meter, strong hydraulics, tight boom and head, undercarriage is in good working condition, has some blow by, tight controls, newer control valves. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA.

Tigercat L830 2003
$Call for Price
John Deere 548GIII Skidder ***SOLD***

John Deere 548GIII Skidder ***SOLD***

2013 John Deere 548GIII Grapple Skidder with Winch. This machine has 3,500 hours, runs and starts good, strong hydraulics and transmission, tight center pins, grapple is in good working condition, 28Lx26 tires @ 75%, heat, A/C, and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA. ***SOLD***

John Deere 548GIII 2013
$131,500
CAT 518 95U SN Skidder ***SOLD***

CAT 518 95U SN Skidder ***SOLD***

1990 CAT 518 95U SN Skidder with ~3,500 hours. This machine has (3) 34.00x26 tires, 1 28L26 tire. CAT 3304 engine, grapple and winch, brush blade with extensions. Machine runs out very well. $4,000 ground freight to port of Houston. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***REDUCED FROM $29,900.00***

CAT 518 95U SN 1990
$22,900
John Deere 648GIII Skidder

John Deere 648GIII Skidder

2004 John Deere 648GIII D/A Grapple Skidder. This machine has 15,255 frame hours, engine and transmission were rebuilt at 9,000 hours, runs and starts good, Direct Drive transmission, strong hydraulics, no winch, tight pins and bushings, heavy Sweda axles, good tires and chains, heat, and A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

John Deere 648GIII 2004
$57,500