Sort By:   GridGallery
Photo Title
Make Model Year Price
Tree Farmer C5D Skidder

Tree Farmer C5D Skidder

1988 Tree Farmer C5D Cable Skidder with CanCar Winch. This skidder has a 5 cylinder Deutz engine, runs and starts good, good on fuel. Strong hydraulics and 4 speed manual transmission. Blade cylinders were redone. Winch control was rebuilt. New batteries. New alternator. 18.4 x 26 tires@ 90% with Bear Claw chains, 9/16 mainline. Clean dry skidder. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Tree Farmer C5D 1988
$22,500
John Deere 640E Skidder

John Deere 640E Skidder

1993 John Deere 640E Cable Skidder. This skidder has a newer PowerTech engine 2 years ago, less than 500 hours on engine. Strong Power Shift transmission, tight center section, good axles, strong hydraulics and cylinders. Winch is in good working order. 67/34.00-25 Tires @ 75%. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southeast USA.

John Deere 640E 1993
$44,500
John Deere 848H DA Grapple Skidder

John Deere 848H DA Grapple Skidder

2008 John Deere 848H DA Grapple Skidder. This equipment has a new John Deere engine, runs and starts good, strong hydraulics and cylinders, transmission rebuilt 500 hours ago, new wiring harnesses all in the last 500 hours. Complete new rear boom and grapple in the past 500 hours. Firestone 35.5 tires new within the last 500 hours. New set of chains. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southeast USA. REDUCED FROM $130,000.00

John Deere 848H 2008
$115,000
2005 John Deere 748GIII

2005 John Deere 748GIII

2005 JOHN DEERE 748GIII DUAL ARCH GRAPPLE SKIDDER 6 CYL DEERE 30.5-32 RUBBER

John Deere 748GIII 2005
$62,900
Tigercat 230B Loader ***SOLD***

Tigercat 230B Loader ***SOLD***

2004 Tigercat 230B Loader with a CTR 42IP Bar saw Slasher and CTR 320 Delimber. This equipment has a Cummins 5.9 engine, runs and starts good, block heater was installed, strong hydraulics and cylinders, tight boom and grapple. CTR 320 delimber and ground saw are in good working order. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***

Tigercat 230B 2004
$49,500
John Deere 648L Skidder

John Deere 648L Skidder

2016 John Deere 648L Dual Arch Grapple Skidder. Hour meter reads 4,115 hours, starts & runs good, strong hydraulics and cylinder. Winch is in good working order. Tight center section, grapple and arch are tight as well. One brand new tire all others are at least 70% tread. All new chains spring 2020. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

John Deere 648L 2016
$145,500
Siiro S-150 60" Slasher Table ***SOLD***

Siiro S-150 60" Slasher Table ***SOLD***

Siiro S-150 60" Slasher Table. This slasher has strong hydraulics and pump, decent hoses, straight blade, good teeth, hydraulic butt board. Table is marked for 8', 10', 12', 14', & 16' on table frame. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD**

Siiro S-150 Unknown
$7,500
Ponsse Ergo Harvester with H7E Processing Head

Ponsse Ergo Harvester with H7E Processing Head

2002 Ponsse Ergo Harvester with H7E Processing Head. This equipment has a Mercedes Benz engine, runs and starts good, strong hydraulics and cylinders, HN 125 Crane. Fire suppression. Webasto pre-heater. 700/50-26.5 tires, strong boom, head is in good working order. Heat, A/C,and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Ponsse Ergo 2002
$85,000
Ponsse Ergo Harvester with H7E Processing Head

Ponsse Ergo Harvester with H7E Processing Head

2003 Ponsse Ergo Harvester with H7E Processing Head. This harvester has a Mercedes Benz engine, starts & runs good, strong hydraulics and cylinders, HN 125 Crane. Tight center section, bogies are in good working order. Fire suppression. Webasto pre-heater. 700/50-26.5 tires, strong boom, head is in good working order. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Ponsse Ergo 2003
$102,500
Barko 495ML Magnum Loader w/Hanfab 72" Slasher Saw *SOLD*

Barko 495ML Magnum Loader w/Hanfab 72" Slasher Saw *SOLD*

2012 Barko 495ML Magnum Self Propelled Loader with Hanfab 72" Slasher Saw. This equipment has a Cummins engine, runs and starts good, hour meter reads 13,625 hours. Strong hydraulics and cylinders. Tight boom and Rotobec bucket. Live Heel. 40' Savage self propelled carrier. Mounted generator with 3,300 hours. Heat , A/C, and lights. Well maintained. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

Barko 495ML 2012
$89,500
Timberjack 608 Feller Buncher ***SOLD***

Timberjack 608 Feller Buncher ***SOLD***

2000 Timberjack 608 Feller Buncher with a John Deere FS20 Hot Saw. This equipment has a 40 degree tilt, Quadco 2-3/8" beaver teeth, LED lights all the way around. CAT undercarriage in good shape, 24" double grouser steel tracks, enclosed cab with heat, works great and has A/C but isn't hooked up. Has owners manuals. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

Timberjack 608 2000
$49,900
Timberjack 1110 Double Bunk 8 Wheeled Forwarder ***SOLD***

Timberjack 1110 Double Bunk 8 Wheeled Forwarder ***SOLD***

2001 Timberjack 1110 Double Bunk 8 Wheeled Forwarder. This equipment has a Cummins engine, starts & runs good, strong hydraulics and drive system, bogies are in working order, tight boom and grapple, squirt boom works, decent center bearing, 700 rubber. TJ71F72 Loader, blade. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

Timberjack 1110 2001
$52,000