1996 Timbco 415B Harvester with a Fabtek Roller II 18" Head. This machine has a new undercarriage in Nov. 2017 - is @ 95%, spring 2017: new seat, joysticks, front window, and LED lights on front . New Parker Denison pumps in 2015 and new pump drive in 2015. John Deere engine was rebuilt in 2012, 8,500 hours on it at that time, everything but the injectors and turbo, as the previous owner had just replaced them. Newer injectors and turbo on it in fall 2017. Has a revamped 2 roller Fabtek head 18" with on board L 90 Parker valves, High Country Tech computer. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2011 Komatsu 911.4 Harvester with a 370.2 Head. This machine has 6,700 hours, Sisu engine- runs and starts good, has quick couplers, set up for a pre heater, new batteries, strong hydraulics and cylinders, leveling system is in good order, tight pins and bushings, bogies are in good order, extenda-boom in good condition. Measuring system working as it should, feed rollers and grab arms are in good condition. 700 tires @ 60% with tracks. Heat, A/C, lights, and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2000 Timberjack C45 Skidder with Esco Grapple and Winch. This equipment has been converted over from a trimmer with only 1,200 hours, Cummins 5.9 6BT engine, runs and starts good, 4 speed auto transmission, 100" Esco grapple, 30 ton winch, tight center section, strong hydraulics and cylinders, 67x34.00 tires. Heat & A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2014 CAT 324D Harvester with Southstar 600 Head. Hour meter reads 5,774 hours, starts & runs good, strong hydraulics and cylinders, tight boom and head, new rod and main boom cylinder pins, 28" DG, undercarriage is @ 65%, grab arms and rollers are in good condition, measuring system and DASA 5 computer are in good order. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada.

1996 John Deere 540E Cable Skidder. This equipment has a 6059T engine, Powershift transmission, 13,700 frame hours, 28L x 26 tires at approx 30%, some play in the center pin, new carrier bearing, new seat, good brakes, good clutch, new exhaust, new master switch. Recently fixed drive shaft, new 3/4" mainline, rebuilt arch, open air cab, quick couplers for cold starts. New chains all around. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1991 John Deere 548E Turbo Grapple Skidder with Winch. This skidder has a reman 4 cyl. engine 3,060 hours ago, runs and starts good, Power Shift transmission is in good working order, tight pins and bushings in the center and grapple, strong hydraulics and cylinders, 28Lx26 tires @ 40%, axles and cradles are in good condition. Heat and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.