1996 Clark Ranger 665D Grapple Skidder with Winch. This machine has a Detroit 353T engine, 3 speed Clark auto shift. Engine was rebuilt, paperwork available. After 80 hours on rebuild coolant leaked into the oil somehow. It has not been ran since, it was caught right away, it still runs and drives to load and unload. It is a good tight machine with lots of power for someone who wants to put in the effort to repair it. Oil was changed out right away. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

Bombardier SW 65 Tracked Snowcat with Snow Plow Blade. This equipment has a Chrysler 350 6 cylinder gas engine with 3 speed manual transmission, pull handle steering brakes. Auxiliary hydraulic controls in the cab, hoses in the rear, snow plow blade, rear hitch, passenger seat. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

1997 Barko 160C Self Propelled Loader. This equipment has a Cummins 5.9 engine, runs and starts good, strong hydraulics and cylinders, few minor leaks. Has slasher hook ups, tight boom, dead heal, swing gear in good condition, Rotobec 360 grapple has been welded and reinforced. Joystick controls, good drive system. Heat and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

2015 Timberpro TF830C 8 Wheel Forwarder. Hour meter reads 3,679 hours, Cummins QSC 8.3L Pre-DEF engine, runs and starts good. Extend-a-Boom. Collapsable headache rack. Very dry machine - no evidence of engine or hydraulic leaks. Clean inside and out. Fire suppression system. SuperGrip grapple. Hydraulic Pre-Heater. 4 stakes and stake pockets included. 710/45-26.5 Nokian Forest King F2 tires. Currently set up for hauling mats with aftermarket mat supports that affix to bunks (may or may not be included with machine at this point). Recently serviced. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

2014 Vermeer WC2300 XL Whole Tree Chipper. Hour meter reads 3,965 hours, CAT C13 440 HP Tier 3 Engine, runs and starts good. 5/8" cut babbitted knives, standard discharge chute. Trailer lighting, super single wheels, air compressor assembly. Includes enclosure and air dryer, remote. Well maintained. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1999 Timbco T416-D Feller Buncher with a Quadco 20" Head. This buncher has 4,600 hours on a Cummins 8.3 engine, runs and starts good, strong hydraulics and cylinders. Everything works as it should, repacked main and stick cylinders. 65-70% on a D6 undercarriage, 24" single grouser pads. Quadco 20" 40 degree tilt has new teeth. Tight boom. Heat, A/C, & lights all work. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA ***SOLD***