Sort By:   GridGallery
Photo Title
Make Model Year Price
John Deere 548GIII Skidder

John Deere 548GIII Skidder

2006 John Deere 548GIII Grapple Skidder with Winch. This skidder runs and starts good, strong hydraulics and transmission, cylinders are in good working order, dry and tight, everything works as it should. Winch is in good working condition. Lights, wipers, heat, and A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

John Deere 548GIII 2006
$82,500
Morbark 23 NCL Whole Tree Chipper

Morbark 23 NCL Whole Tree Chipper

2007 Morbark 23 NCL Whole Tree Chipper. This equipment has a CAT 3412 750 HP engine, runs and starts good, engine was turned down to 750, new clutch, knives and disc are all in good work order, hydraulic feed wheel is in good condition, remote control, Hydraulic swivel/telescoping discharge spout, good brakes and tires. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Morbark 23 NCL 2007
$150,000
Timberjack 1270B Harvester with a 762C Head

Timberjack 1270B Harvester with a 762C Head

1999 Timberjack 1270B Harvester with a 762C Head. Per owner, this machine has a Navstar DT 466 engine that has been gone through, runs and starts good. Strong hydraulics, pump has been replaced. Boom and steer cylinders are in working condition. Head, CPU, and measuring system are in working order. New windshield. 710 tires, bogies and bearings are in good condition, tight center, pins and bushings have normal wear, engine pre-heater, heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Timberjack 1270B 1999
$32,500
Tigercat 230B Loader with CTR 42IP Ground Saw

Tigercat 230B Loader with CTR 42IP Ground Saw

2004 Tigercat 230B Loader with CTR 42IP Ground Saw. This loader has around 8,000 hours, Cummins 5.9 engine, runs and starts good, block heater recently installed, recent Cummins seals, hoses, high pressure pump, solid boom and grapple, Pitts 42' carrier, good brakes and tires. CTR 42IP Ground saw areall in good working order, pilot controls. Heat, lights, A/C, needs charged. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Tigercat 230B 2004
$58,500
John Deere 643K Feller Buncher

John Deere 643K Feller Buncher

2013 John Deere 643K Feller Buncher with a FD45 Head. Hour meter reads 2,350 hours, John Deere 189 HP engine, starts & runs good, strong transmission with infinitely variable hydrostatic with two-speed gearbox, durable and reliable hydraulic and electrical plumbing, TeamMate IV™ 1400 heavy-duty (HD) axles both front and rear, deliver the tractive effort and stability your cutter needs. Fast ground speed and saw recovery. HD45 head is in good working order with extra set of teeth. AM/FM radio and CD player. 2 8Lx26 tires @ 75% with 1 set of single diamond chains @ 75%. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

John Deere 643ZK 2013
$139,500
Prentice 410E Loader with Ground Saw & Delimber

Prentice 410E Loader with Ground Saw & Delimber

1999 Prentice 410E Loader, Ground Saw, and CTR Pull Through Delimber. This equipment has a Cummins engine, runs and starts good, strong hydraulics, tight joystick controls, tight boom, main cylinder was just rebuilt, continuous rotation grapple, Delimber and ground saw are in good working order, decent tires and brakes, heat, lights, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Prentice 410E 1999
$34,990
Timberjack 200 Cable Skidder

Timberjack 200 Cable Skidder

1974 Timberjack 200 Cable Skidder. This machine has a 353 Detroit engine, runs and starts good, block heater, 4 speed manual transmission. New ignition, new chokers. Mainline is a little short. Hercules winch, with new master cylinder, winch band, & brass gear. Rebuilt front blade cylinders. Also has parts machine for extra cost. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Timberjack 200 1974
$9,900
Morbark 23 WCL Chipper ***SALE PENDING***

Morbark 23 WCL Chipper ***SALE PENDING***

1988 Morbark 23 WCL Chiparvestor Whole Tree Chipper. This machine was completely gone through, hour meter reads 1,200 hours, has a CAT 3412 850 HP engine, runs and starts good, engine was 1150 HP turned down to 850 HP, new clutch, knives and disc are in good work order, hydraulic feed wheel is in good condition, Morlift 500 loader, good brakes, and tires. Has a Morbark feed table to pin to the machine that can be purchased separately. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SALE PENDING***

Morbark 23 WCL 1988
$175,000
Bobcat 1080C Feller Buncher ***SOLD***

Bobcat 1080C Feller Buncher ***SOLD***

1987 Bobcat 1080C Feller Buncher. This feller buncher has a Cummins 4BT engine. According to owner, the engine starts & runs good, has strong hydraulics and cylinders, a new tilt cylinder, and the shear is set up with electric over hydraulic controls. Planetary axle is in good order, hour meter reads 9,900 hours. 16" Clark shear head with new knives; grab arms are in good working condition and tracks are newer. New 19.5 14 ply tires. Machine has heat and Lexan door. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

Bobcat 1080C 1987
$19,500
Truck Mounted Serco 800 loader with Slasher Saw ***SOLD***

Truck Mounted Serco 800 loader with Slasher Saw ***SOLD***

Serco 8000 Loader on a 1979 Ford 9000 Truck with a 60" Hood Slasher Saw. According to owner, truck has a 671 Detroit that runs well with a 4x4 manual transmission. Serco 8000 loader with heat, windshield is cracked. Nice tight machine with a few minor hydraulic leaks. 4 cylinder John Deere power plant for loader, runs and starts good, new hydraulic pump, fresh fuel filters and oil change. 60" Hood slasher with adjustable back stop - 100" to 124" bunk in good shape, some cracks on slasher have been welded. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ral USA. ***SOLD***

Serco 8000 Unknown
$15,000
Morbark 20 Whole Tree Chipper

Morbark 20 Whole Tree Chipper

1988 Morbark 20 Whole Tree Chipper. This equipment has a 855 Big Cam Cummins engine, runs and starts good, 200 gallons of fresh fuel, new oil and filters, this is a newer engine not original, strong hydraulics, newer 2" return line, new batteries, knives and jig are in good order, 7/8 chips, newer exhaust, good tires and rims, cab is heated. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Morbark 20 1988
$26,500
John Deere 440C Cable Skidder

John Deere 440C Cable Skidder

1982 John Deere 440C Cable Skidder. Hour meter reads 8,500 hours, hour meter is believed to be original & working. Following parts are new or recently replaced: batteries, fuel lift pump, seat, alternator, radiator and winch bands. 18.4x26 Firestone Forestry Special tires @ 90%, single diamond chains on the rear of skidder, tight ring chains on front. 2 newly rebuilt steering cylinders. 5/8" Super Swedge mainline. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

John Deere 440C 1992
$32,900