Sort By:   GridGallery
Photo Title
Make Model Year Price
Morbark 628 Debarker ***SOLD***

Morbark 628 Debarker ***SOLD***

2005 Morbark 628 Debarker. This equipment has a 100 HP electric motor, cab, 25' in-feed trough, 20' out-feed trough, stands. Runs daily. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southeast USA. ***SOLD***

Morbark 628 2005
$40,000
Morbark 636 Debarker ***SOLD***

Morbark 636 Debarker ***SOLD***

Morbark Model 636 3 Phase Electric Debarker. 2 Linclon 100hp electric motors for debarker and conveyor. 50hp Lincoln Electric motor for live deck. Enclosed cab with controls. 60' in-feed trough, 60' out-feed trough. Bark conveyor included as well. 3 strand live deck, 20' width. Machine operates as it should and was working daily until recently. Buyer will be responsible for disassembling and moving equipment prior to 1/15/2020. Equipment located near Wilmington, NC. Seller will assist in arranging transport. ***SOLD***

Morbark 636 Unknown
$60,000
Prentice 410E Loader with Ground Saw & Delimber

Prentice 410E Loader with Ground Saw & Delimber

1999 Prentice 410E Loader, Ground Saw, and CTR Pull Through Delimber. This equipment has a Cummins engine, runs and starts good, strong hydraulics, tight joystick controls, tight boom, main cylinder was just rebuilt, continuous rotation grapple, Delimber and ground saw are in good working order, decent tires and brakes, heat, lights, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Prentice 410E 1999
$33,500
Timberjack 380 Skidder

Timberjack 380 Skidder

1984 Timberjack 380 Dual Arch Grapple Skidder. This skidder has been updated to a Cummins 5.9 engine and 3 speed Clark transmission, new alternator and starter, new belts, all fluid have recently been changed, 101' grapple, strong hydraulics and cylinders, few minor leaks. 28Lx26 tires @ 50% with ice chains, enclosed cab with doors, heat, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Timberjack 380 1984
$18,500
Timberpro 725D Harvester with Waratah 622B Head

Timberpro 725D Harvester with Waratah 622B Head

2018 Timberpro 725D Harvester with a 2013 Waratah 622B Harvester Head. Carrier has 1,600 hours, Cummins engine, runs and starts good, pre heat system, air ride and heated seat, backup camera, single grousers in excellent condition. Waratah 622B has approximately 9,000 hours, Timbermatic computer system. 24" pads, counter weights on tracks as well, heat, A/C, and LED lights. Warranty until 2,000 hours. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Timberpro 725D 2018
$Call for Price
Prentice ATL 425 Log Loader

Prentice ATL 425 Log Loader

1990 Prentice ATL 425 Log Loader. This equipment has a Cummins 8.3 engine, good drive system, strong hydraulics, tight boom and grapple, cord and a half Rotobec grapple or other grapples available, extended boom, joystick pilot controls, out riggers are in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Prentice ATL 425 1990
$19,900
Ponsse Ergo Harvester with H7 Head

Ponsse Ergo Harvester with H7 Head

2012 Ponsse Ergo Harvester with H7 Head with big saw box. Hour meter reads 11,675 hours, Mercedes Benz engine, runs and starts good. Complete service by Ponsse at 11,200 hours. Updated fire suppression system, tight C4 crane, strong hydraulics and cylinders. 2 sets of tracks @ 95%. 710 tires, pre-heater. Heat, A/C, and LED lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

Ponsse Ergo 2012
$250,000
Valmet Series II 6 Wheel Forwarder

Valmet Series II 6 Wheel Forwarder

1994 Valmet Series II 6 Wheel Forwarder. This forwarder runs and starts good, lever steer, Clark 3 speed transmission, 23.1 x 26 front tires and 600 rears, pins have a little play. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Valmet Series II 1994
$22,900
Ponsse Ergo 6WD Harvester

Ponsse Ergo 6WD Harvester

2009 Ponsse Ergo 6WD Harvester with a H7 Head. This equipment has 2,500 hours since a Ponsse reman was done, Mercedes Benz 6 cyl. engine, runs and starts good, pre-heat system, strong hydraulics and cylinders, bogies are in good working order, tight boom, squirt boom works as it should, solid boom base. Pumps are all in good working order, tight center section. Head and measuring system are in good working order, 710 tires with tracks, good glass. Heat, A/c, and LED lights. Contact Aaron @ Red Pine Equipment 218 -720-0933. Equipment is located in Northcentral USA.

Ponsse Ergo 2009
$169,000
Franklin 132 Forwarder

Franklin 132 Forwarder

1994 Franklin 132 Single Bunk Forwarder. This machine has a 4BT Cummins engine, runs and starts good, strong hydraulics and transmission, tight boom and grapple, cylinders are all in good order, main boom cylinder was repacked, heat, A/C needs a new belt, 23.1x26 tires @ 85%. Working Daily. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Franklin 132 1994
$27,500
Valmet 646 Forwarder ***SOLD***

Valmet 646 Forwarder ***SOLD***

1997 Valmet 646 Double Bunk Forwarder. This equipment has a Cummins 4BT engine, runs and starts good, pre-heater. Power Shift transmission, joystick controls. Cranab extended boom loader with Supergrip grapple, new center section pins, newer pump. 28L x 26 tires on front and 700 rear. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

Valmet 646 1997
$43,500
Ponsse Caribou Forwarder

Ponsse Caribou Forwarder

2003 Ponsse Caribou Forwarder. This equipment has a Mercedes Benz Engine, runs and starts good, strong hydraulics and cylinders, tight extended boom and grapple, bogies are in good working order, Pro Heat is not working, 500 tires with chains. Heat, A/C, and LED lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Ponsse Caribou 2003
$79,500