1985 John Deere 648D Dual Arch Grapple Skidder. This skidder has 1,270 hours on a rebuilt engine, 100 hours on a new injection pump, new starter & new Lexan in 2017, rebuilt grapple cylinder last winter, new cutting edge on blade, rebuilt parking brake and rear end, newer batteries, rear tires are @ 80%, front tires are @ 10%, center and steering pins have play. Hydraulics are slow at times, works to load and drive will need to be addressed before woods ready. Transmission is strong. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2015 CAT 501HD Processor with Fabtek 4 Roller Head. This machine has 5,200 hours, runs and starts good, strong hydraulics and cylinders. Extras include Jet Fit Bar System, auto grease. Pre-heater for engine, cab and hydraulics, fire suppression, 24" double grouser pads. Undercarriage is @ 75% and in very good shape for the amount of hours. Fabtek head and measuring system are all in good working order. Heat, A/C, lights, and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1993 HAHN HTL 300F Self Propelled Harvester. This machine has a John Deere 6359 turbo engine, runs and starts good, strong hydraulics, hoses are all in good order, tight controls, drive system is in good working condition, new feed chain, delimber knives and measuring system are in good working order, tight controls, topping saw and chain have been repaired, new bar and chain, tight boom and grapple. Cab has heat and good glass. Has service and parts manual. Easy fifth wheel hook up for travel. Tire chains. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northwest USA.

2008 Ponsse Ergo Harvester with H7 Head. This equipment has a Mercedes engine, runs and starts good, strong hydraulics and cylinders, new conical pins in the crane base and upper and lower in the pillar. 6/20/18 all new pressure hoses, case drain hose and steal lines inside the boom. All new inner and outer swing gear bolts. bogies are in good order. Computer was just cleaned out at Ponsse. 710 tires are good with 1 set of tracks. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2012 John Deere 1210E Double Bunk 8 Wheel Forwarder with Rotating Cab and Squirt Boom. ~8,300 hours, very dependable starting and running machine, block heater, bogies are all in good order, minor play in boom, tight controls, tight center section, all cylinders are dry and in good working order, blade, heat, A/C, lights and radio, machine has been very well maintained. New 710 tires all around, good glass, SureGrip grapple. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

2007 Morbark 23 NCL Whole Tree Chipper. This equipment has a CAT 3412 750 HP engine, runs and starts good, engine was turned down to 750, new clutch, knives and disc are all in good work order, hydraulic feed wheel is in good condition, remote control, Hydraulic swivel/telescoping discharge spout, good brakes and tires. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.