| Photo |
Title
|
Make | Model | Year | Price |
|
Bandit Intimidator 15XP Chipper2020 Bandit Intimidator 15XP Chipper. Hour meter reads 560 hours. Ford 165hp gas engine. Winch & electric powered jack. Garage kept, includes an extra set of knives. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. |
Bandit | Intimidator 15XP | 2020 |
$60,000
|
|
Prentice 325 Log LoaderPrentice 325 Log Loader. Owner states 8,000 hours on meter. Boom and grapple are tight, has a dead heel. Brakes are good and lift axle works. Tires are estimated at 20-60%. Outriggers are functional. Heat and A/C in cab. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. |
Prentice | 325 | - |
$21,000
|
|
Woodsman 430T Track Drum Chipper2011 Woodsman 430T Track Drum Chipper. Hour meter reads 4,946 hours. Cummins QSX15 600hp engine, pre-DEF. PT Hydraulic Clutch. 32" triple grouser pads, undercarriage is estimated at 80%. Drum is good, no pitting, feed chain is also good. Babbitt style knife system. One new travel motor, new main drive belt. Wireless remote control, unit has original paint. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA. |
Woodsman | 430T | 2011 |
$117,900
|
|
Valmet 546 Forwarder1999 Valmet 546 Forwarder. Hour meter reads 6,000 some hours but doesn't work. Valve bank has been completely rebuilt. New center section, fully rebuilt, cylinder got new rods and seals. New 23.1x26 front tire. Bogie tires are estimated at 15-30%. Newer ponsse grapple is tight. New glass. Heat works, A/C is there but not sure if functional. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. |
Valmet | 546 | 1999 |
$31,000
|
|
Hydro-Ax 511B with Shear Head1989 Hydro-Ax 511B with 20" Shear Head. HD heavier duty axles. Reman engine with less than 1,000 hours. Has the valve bank and setup for a mulching head. Center pins were bored and replaced 500 hours ago. 28Lx26 tires are estimated at 50% or greater. Windows could be replaced. Heat, A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral. |
Hydro-Ax | 511B | 1989 |
$19,500
|
|
J. Koller K300 Trailer-Mounted Cable YarderJ. Koller K300 Trailer-Mounted Cable Yarder. Self-contained, steep-slope yarder. Hour meter reads 2,586 hours. 1,500' of cable. Deutz engine. Unit is in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. |
J. Koller | K300 | - |
$44,500
|
|
Hahn HTL300 Delimber/HarvesterHahn HTL300 Delimber/Harvester. Hour meter reads 239 hours. Cummins 6BT engine. 11R24.5 tires range from 20%-90%. Unit is in working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. |
Hahn | HTL300 | - |
$23,500
|
|
CAT 225 Log LoaderCAT 225 Log Loader. CAT 3208 engine. Hours are unknown. 24" triple grouser pads, undercarriage is estimated at 60%, rails are good and live new, sprockets are around 30%. Live-heel loader. Unit is in working order. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. |
CAT | 225 | - |
$27,500
|
|
PistenBully Snowcat with Farmi 3967 Loader & Naarva ShearPistenBully Snowcat with 2010 Farmi 3967 Loader & Shear. Mercedes engine starts and runs good. Naarva grip tree shear on the front is in good condition, has a tilt cylinder to lay down trees. Farmi Loader on the rear has a cab too, unit is ran with two operators. Integrated Valby 9" chipper is great for aspen. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. |
PistenBully | Snowcat | Unknown |
$77,500
|
|
TimberPro TL745C Feller Buncher with Quadco 22" 360° Head2016 TimberPro TL745C Feller Buncher with Quadco 22" 360° Head. Hour meter reads 6,500 hours. 24" single grouser pads, undercarriage is estimated at 75%. Quadco 22" 360° rotating head is in good condition. Espar preheater. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Canada. |
Timberpro | TL745C | 2016 |
$342,500
|
|
Serco 170 Loader with Siiro 60" Slasher1993 Serco 170 Loader with Siiro 60" Slasher. John Deere engine starts and runs good. Loader sits on a 1979 Mack truck that works well. Loader is tight, has a brand new main lift cylinder. Blade is straight, new teeth. Hydraulic landing gear works as it should. Heat in cab. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. |
Serco | 170 | 1993 |
$44,500
|
|
Komatsu PC220 with Log Max 7000XT Harvesting Head2007 Komatsu PC220 with Log Max 7000XT Harvesting Head. Hour meter reads 10,940 hours. 36" triple grouser pads, undercarriage is estimated at 80%. Log Max 7000XT harvesting head is in good working order, topsaw and sawbox in good condition. Suregrip joystick controls. Heat. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA. |
Komatsu | PC220 | 2007 |
$82,500
|