Completely rebuilt John Deere 748 G Log Skidder. Crate reman engine approx. 3,000 hours ago. Pumps were done at the same time as engine. New power shift transmission last summer. Radiator, charge pump, steering motor, steering cylinder pins and bushings, both differentials, cradle, arch, and center pins completely redone 3-400 hours ago, new brake and pins in grapple, 44 floatation tires at 50% dual fuel tanks, new air ride seat, new glass, LED lights, heat and A/C. (New A/C motor, condenser, and fans.) Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2005 John Deere 648GIII TC Log Skidder with Winch. Meter shows 3,200 hours. Actual hours believed to be 13,200. Trail blade, 30.5x32 rubber in decent shape, one tire has small section of side wall missing. One set of DD chains included at ~30%. Very few leaks seen. Machine has been well cared for. Winch installed on machine but missing drive shaft, no cable on winch. Heat and A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1980 John Deere 440-C Cable Skidder. This skidder runs and starts good, 4 speed manual transmission, center section was rebuilt, strong hydraulics and cylinders. New clutch, axel seal, & shifting plate. Replaced drive shaft, neutral safety switch, and shut off switch. Good brakes. Strong winch. 18.4 x 26 tires @ 50% with a set of single diamond chains. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2003 John Deere 648GIII Dual Arch Grapple Skidder. This skidder starts and runs good, strong hydraulics and cylinders. Direct drive transmission is in good working order, tight center section, decent pins and bushing on the arch, grapple pins have a little play. Axles and cradles are in good working order, lots of new hoses, recently packed cylinders, tires are @ 75%, New glass front and rear, new air ride seat. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southwest USA.

1988 John Deere 540B Grapple Skidder with Winch. This equipment has a 4 cyl. John Deere engine, runs and starts good, strong hydraulics and Power Shift transmission, cylinders are in good working order. Tight center section, arch, and Esco grapple. 30.5 x 32 tires. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

1988-89 John Deere 548D Grapple Skidder with Winch. This machine starts & runs good, engine and Power Shift transmission have recently been rebuilt, sleeves, pistons, new injectors, new water pump, strong hydraulics and cylinders, few minor leaks, tight center section, new pins on steer cylinders, arch and grapple in good condition, strong winch. New mainline. 28Lx26 tires @ 60% with 2 sets of Bear Claw chains like new. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.