2011 TimberPro TL-725B Harvester with a Rolly II Head. Hour meter reads 9,700 hours, Cummins 8.3 engine, runs and starts good, new pan gasket and main seal, flex plate was done at the same time, valve banks were gone through and resealed. Espar pre heat system, fire suppression system. Strong hydraulics, and cylinders, drive pumps are in good working order, 2 new final drives. Undercarriage is @ 50%, 24" single grouser pads. Newer house bearing 1,500 hours ago. Rolly II head, grab arms and both bottom and topping saw are in good working condition. Dasa 4 computer, good glass, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2013 TimberPro TL-725B Harvester with a Rolly II Head. Hour meter reads 7,500 hours, Cummins 8.3 engine, runs and starts good, 1,000 hours on a new pan gasket and main seal, flex plate was done at the same time, Espar pre heat system, fire suppression system. Strong hydraulics, new main pump 1,200 hours ago, drive pumps in good working order, new swing bearing and trunnion. Rolly II head has more hours then the machine but is in good working order, grab arms and both bottom and topping saw are in good working condition. Good glass, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Very nice one owner/operator machine. 11,480 hours. Heat & A/C. Preheater. 8.3 Cummins runs like new. Everything works as it should. Tier 3 engine, no def!! Rolly head in very good condition. Clean inside and out. No leaky cylinders. No welds on boom and pins are tight. New sprockets. We do take trades depending on what you have and we can help with delivery if needed. Serial number is 0307-01.

2011 TIMBERPRO TN725B

2014 TimberPro TL735-B Processor with Logmax 7000XT Fixed Head. This machine has a Cummins tier 3 300 HP engine, runs and starts good. 8,100 hours. New injectors, oil pan gasket, and rear engine seal. Pumps resealed and checked. Espar heat engine and hydraulics. Pump drive new input shaft and bearings. All regular maintenance done on schedule, oils changed every 1,000 hours, engine oil every 500 hours. Undercarriage is @ 50%, 24" double grouser pads. Processor head is stronger and more productive than other fixed heads. New Logmate 500 computer and head module. $40,000 in recent updates and work done on machine. New roto bearing on head, new saw motor, new saw bar holder, auto level option, new leveling cylinders, new A/C pump. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

2016 TimberPro TN725-C Processor with a Log Max 7000 Head. This machine has 2,700 hours as of August 30, 2018, Cummins QSC 8.3 - 300 HP engine, Caterpillar D6 size track frames with double-flanged rollers, 24" pads, 6' squirt boom, Lohmann final drives, Rexroth 2-speed motors. 2004 Log Max 7000 has had saw and feed wheel motors replaced, valve bank resealed, new knives, all cylinders repacked. Logmate 400 computer system. Carrier has fire suppression system, Espar pre-heater, deluxe air-ride seat with heat and lumbar support, heat, A/C, and LED lighting. Owner/Operator machine. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.