1994 Timberjack 230A Single Bunk Forwarder. This machine has a Cummins 4BT engine, runs and starts good, strong hydraulics and cylinders, few minor leaks. 5 speed transmission with HI/LO, Serco loader. Tight boom and grapple, new brakes, tight center section. Manual control, 23.1 x 26 tires @ 75%, heat, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA.

2000-01 John Deere 1010B 6 Wheel Forwarder. This machine has newer Cummins 4BT engine less then 1,500 hours, runs and starts good, newer pump, transmission was gone through when pump was done, tight center section, bearing and bushings were done on boom, 23.1x 26 front, 610 rear tires with chains. Heat, A.C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2004 Timberjack 1110D 6 Wheel Forwarder. This machine has a John Deere engine, has been reworked - head gasket and valves, runs and starts good, strong hydraulic pumps and cylinders, center section and center bearing were just re-worked this spring, tight boom, squirt boom has all been gone through, rebuilt lift cylinder, hose tray is new, bogies and bearings were gone through, tight controls, went through rack and bunks, good tires. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

1995 Timberjack 1210 8-Wheeled Forwarder. This machine has a Perkins engine, around 20,000 hours, rebuilt cylinders, tight center, boom has normal wear, 600 tires @ 50%, tracks in back, bogies in good working condition, has heat, and A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2001 Timberjack 1110 8 Wheeled Forwarder. This machine has been very well maintained, 22,500 frame hours, 5.9 cummins engine, runs and starts good, Espar pre-heating system, completely new hydraulics at 17,000 hours (including hydraulic pumps, motors, main crane pump, cylinders, and a complete system flush) hydrostatic pump was redone in 2012. Tight pins and bushings, tight controls, Hultdins grapple has new pins and new rotator. Front tires are @ 50-60%, back tires are around 25%. Tracks are @ 20%, tire chains are @ 75%, has A/C, heat, and LED lights. Has parts and service manuals. Machine is currently working daily. Contact Erik @ Red Pine Equipment 218-720-0933. Machine located in Northcentral USA.***SOLD***