All listings for: RedPineEquipment

1980's Morbark 22RXL Chipper. This machine has 600 hours on a Cummins K18 engine, newer twin disc clutch, 5/8 chips, feed chain is in decent condition, strong hydraulics, carrier is ready to go. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

1997 Dynaweld 35ton NGB RGN Lowboy Trailer. This equipment has a 22' center well, 24' well on sides, ramps on back for easy loading front or rear. Air ride. No pony motor - needs wet kit, deck is worn, lumber available to re-deck if necessary. Tires - back axle are new, front axle are 50% or better. Due for DOT in fall. Frame is decent, no major rusting, blasted and painted 8-10 years ago. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

5 Blade 18" Trimmer Saw. Has hydraulic box, Blades are 90%. Contact Erik @ Red Pine Equipment 218-720-0933. Saw is located in Northcentral USA. ***SOLD***

Custom Designed and Manufactured Firewood Processor. This processor comes with 2 identical power units to run it. 2 Zetor 7211 tractors that give all the power it needs at an incredible fuel consumption ratio. If one needs maintenance, simply unhook it and put the other one on identically. It also comes with a 60 inch Simmonds Kodiak carbide tip slasher saw capable of cutting up to a 26" diameter log. The splitting system is 2 vertical splitters capable of splitting 2 way 4 way and 8 way blocks. The biggest benefit of the vertical splitters is that each block is split perfectly according to it's size and shape! The hydraulics are run by a John Deere Piston pump at 2,200 LBS. pressure run by the PTO of the power unit 75 HP Zetor 7211 tractors. The Hydraulic cylinder that controls the up and down movement of the slasher blade is run off the remotes of the same Zetor 7211 tractor. The 32' conveyor is run off the hydraulic system of the processor and is easily hooked up to the back of the processor for easy transportation and moving from the pile at the end of the day. This processor will easily do 2 full cords per hour of perfectly split firewood with 2 people. It comes with a supply of almost every replaceable part the machine would need. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Canada. ***SOLD***

2006 Bandit 280XP Chipper. This machine has been completely refurbished in 2017 with a new CAT C4.4 engine, 183 hours, 18” capacity. Winch kit. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

1994 Barko 160B Trailer Mounted Loader. This equipment has 6 cylinder Cummins, runs and starts good, good oil pressure and hydraulics, pretty tight for its age, has a couple minor leaks, main bearing is strong, has a hood bypass bucket - has a little play, lever controls. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***