Featured in Logging Equipment

2008 Tigercat 1055B 8 Wheel Double Bunk Forwarder. Hour meter reads ~18,000 hours. Mercedes engine, hydrostatic transmission. 710 tires are estimated at 50%, includes a set of rear tracks that are in good condition. Heat & A/C. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA.

2008 John Deere 1270D Harvester. 11,000 hours. Recent new injectors in engine which runs and starts good. H480 head has been rebuilt. 2 outer drive motors and one inner motor were rebuilt recently. Espar engine, hydraulic, and cab preheat system, strong hydraulics and cylinders, reman work pump and drive pump in the last 500 hours, tight boom and center section, stick and lift cylinders redone, bogies are in good working order, solid rear ends, 700 tires @ 50% with rear tracks, one set of chains. Feed rollers and grab arms are in good condition, Timbermatic HHM 300 computer. Heat, A/C,and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2008 Valmet 425EXL Feller Buncher with a 20" 40 Degree Quadco Head. This buncher has a Cummins 8.3 engine, runs and starts good, hour meter reads 11,800 hours. strong hydraulics and cylinders. Leveling system and swing bearing are in good condition. Both pumps have been replaced. Espar pre heater. Undercarriage just gone through new sprockets, new bottom rollers, and new 28" double grouser pads. Just went through some hoses and valve bank. Heat works, A/C needs a charge. LED lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2008 Valmet 425EXL Feller Buncher with Quadco 22B 360° Head. Hour meter reads 13,369 hours. Cummins 8.3 engine. 24" single grouser pads, undercarriage is estimated at 30%. Leveling system and swing bearing are in good condition. Espar pre heater. Quadco 22B 360° has a good disc and teeth, minimal welding. Heat, A/C, radio. lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

2008 Barko 495ML Self Propelled Loader with a Hanfab 60" Slasher and a Savage Carrier. This equipment has 11,000 hours, engine was rebuilt 6,000 hours, runs and starts good, strong hydraulics and cylinders, self propulsion in good working order, tight boom and grapple, slasher is in good condition, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

2008 CAT 501HD Processor with Fixed Head. This machine has 12,000 hours, runs and starts good, like new undercarriage, strong hydraulics. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***REDUCED FROM $164,500.00***