Featured in Logging Equipment

1999 Valmet 840 6 Wheeled Forwarder. Hour meter reads ~13,000 hours. This machine has a Sisu engine, extenda-boom, tracks and chains, good reliable forwarder, working daily. Major work done includes, valve bank re-seal, rear differential re-seal and brakes, new center oscillation bearings, main boom line bored, new pins and bushings, extenda-boom wear pads, radiator removed and chemical washed, starter and alternator, new A/C pump and expansion valve, new front tire, the rest are 60% or so, new water pump, grapple pins and bushings, new tracks. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

1999 Tree Farmer C5F Forwarder. Reman Cummins 4BT engine starts and runs good. 4 speed Franklin PowerShift automatic transmission shifts well. 23.1x26 tires are estimated at 60%. 10 hours on valve bank & hydraulic pump. Franklin 4600 Magnum Loader. Heat, A/C, lights, and pilot controls. Can be sold with new tires for $68,000 or used tires for $58,000. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

1999 Timberjack 608 Feller Buncher with Quadco 22 Head. Hours are unknown. Cummins 5.9L engine starts and runs good. 24" double grouser pads, undercarriage is estimated at 80%. Quadco 22" 40° head is in good condition, disc & teeth are good. Boom is tight. Heat, A/C, radio, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

1999 Timberjack 1270B Harvester with a 762C Head. This unit has an International DT 466 engine, runs and starts good, preheat system, &strong hydraulics and cylinders. Pump and hydrostats are in good working order, joystick controls, one joystick has been recently rebuilt, tight boom, boom base has new bearings. 762C head and measuring system is in good condition, 26" bar, new end coder and diameter censor, also has 3 sets of feed rollers, peeling rollers, spiked rollers and rubber rollers. Good front glass installed recently. 600 tires with tracks and chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1999 Timberjack 1270B with 762C Processing Head. Hours are estimated at 22,500 hours. DT 466 engine, hydrostatic transmission. 700/55-34 & 700/50-26.5 tires are estimated at 75%. Newer main pressure and pilot valves. Tight center, pins, & bushings. Squirt boom. Timberjack 3000 computer system. 762C processing head has newer saw assembly, bearing, & auto chain tightener. Heat, A/C, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

1999 Prentice 410E Loader, Ground Saw, and CTR Pull Through Delimber. This equipment has a Cummins engine, runs and starts good, strong hydraulics, tight joystick controls, tight boom, main cylinder was just rebuilt, continuous rotation grapple, Delimber and ground saw are in good working order, decent tires and brakes, heat, lights, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***ON HOLD***