Harvesters/Processors For Sale

1998 Ponsse Cobra HS10 Harvester with a Ponsse H53 Head. This equipment has a Perkins 6 cylinder engine, runs and starts good, 6,500 hours on engine, new flex plate. Center cone bearing was recently redone, tight boom and grapple, double squirt boom extension in good working order, strong hydraulics and cylinders, tight bogies, few minor leaks. Ponsse 1000 computer, head is in working condition, may need a few pins and bushings. 700-45 x 22.5 tires @ 50%. Heat & lights. A/C will need some attention. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Canada.

1999 Timberjack 1270B Harvester with a 762C Head. This unit has an International DT 466 engine, runs and starts good, preheat system, &strong hydraulics and cylinders. Pump and hydrostats are in good working order, joystick controls, one joystick has been recently rebuilt, tight boom, boom base has new bearings. 762C head and measuring system is in good condition, 26" bar, new end coder and diameter censor, also has 3 sets of feed rollers, peeling rollers, spiked rollers and rubber rollers. Good front glass installed recently. 600 tires with tracks and chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1993 HAHN HSW 110B Self Propelled Harvester. This equipment starts and runs good, no major oil leaks. This machine was rebuilt in 2004 with a new crate JD engine. list of repairs, rebuilt inside long stroke/delimber cylinder, new right top knife cylinder, rebuilt cab tilt cylinder, new alternator, replaced front tires. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located Northeast USA. ***SOLD***

2004 Ponsse Ergo 6 Wheeled Harvester with 2007 H73E Harvesting Head. Hour meter reads 15,925 hours. 710/45-26.5 tires are estimated at 65%. 2007 H73E head is in good overall condition. All lights are working. Heat and A/C. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

1998 Timbco 415C Harvester with a 2006 Ponsse H73 Processing Head. Hour meter reads 8,900 hours. John Deere 6068T engine. 24" single grouser pads, undercarriage is estimated at 70%. Pins and bushings are good. Rebuilt hydraulic pump 400 hours ago. The 2006 Ponsse H73 Processing Head has an estimated 4,500 hours. Grab arms and feed rollers are in good working order. Heat, A/C, radio, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2000 JOHN DEERE 120 TRACKED HARVESTER 4 CYL DEERE FOUR ROLLER HEAD INDEPENDENT COUNTER