Chippers For Sale

2010 Bandit 3590XL Whole Tree Chipper. Hour meter shows ~6500 hours. CAT C27 1050 HP w/ optional engine chip to 1370 HP. Engine runs and starts good. Hydronic engine preheated. PT tech clutch. Extended frame, to offset radiator from the engine. Hydraulic reversing fan which increases HP to the chip drum. Upgraded feedbox wall plates to 2" AR 450. Chip pocket upgrades, overs breakers. Overs breaker grates upgrade that bolt in at drum chute. The following upgrades were made at 6,467 hours. New brakes and bearings, new top side of chute, new drum belly wear plate, new infeed chain sprockets, new manifolds and studs 6,467 hours. 36+ inch chipping capacity. Set up for .75" chip size, 2.75+ tons per minute capacity. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA

2011 Rayco RG1220 Brush Chipper. Hour meter reads 225 hours. Kubota 66.8 HP engine starts and runs good. Pre-emission engine. 12" chipping capacity with a 12"x20" in-feed opening. Intake rate of 100 fpm. Discharge swivels 360° and at a discharge height of 112". Feed wheel lift and crush handles on both sides. New battery. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2011 Vermeer WC2300XL Chipper. Hour meter reads 3,973 hours. CAT C13 448 HP engine starts and runs good. Current owner has owned it since 250 hours, was county owned for the first 250 hours. Has a new feed chain, clutch, and belly pan. Oil changed every 200 hours. Includes extra knives. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

2012 Bandit 2590 Chipper. This chipper has a CAT C-15, 540 HP Engine, hour meter reads 4,633 hours and is still in use. Newer remote control kit, exhaust manifold, turbo, and clutch discs. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2012 Morbark 2355 Flail Chiparvestor. Hour meter reads 17,000 hours. CAT C27 engine that was gone through a few years ago. 3 knife, liners are good, flails are in good condition. New PTO system in 2022. Needs new rubbers inside the flails. Includes spare bearings, conveyor chains, flail rods, & filters. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA.

2013 Vermeer WC2300XL Whole Tree Chipper. Hour meter reads 5,587 hours. CAT C13 440hp engine. Brand new turbo and filters. Newer infeed chain bearings and infeed chain. Knives are in good condition. Smart feed. 23" capacity drum style chipper. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***