Sort By:   GridGallery
Photo Title
Make Model Year Price
Komatsu XT430-2 Feller Buncher

Komatsu XT430-2 Feller Buncher

2012 Komatsu XT430-2 Feller Buncher with a 2006 Quadco 2400 Intermittent Sawhead. This equipment has 5,500 hours on the carrier, 8.3 Cummins 300 HP, runs and starts good. Undercarriage was done 1,400 hours ago. 24" pads, boom completely rebushed 1,400 hours ago, many new hoses, 400 hours on all new saw main bearings, finals changed every 500 hours. Clean dry machine, Espar pre heater, Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Komatsu XT430-2 2012
$219,500
Bobcat 1080C Feller Buncher

Bobcat 1080C Feller Buncher

1987 Bobcat 1080C Feller Buncher. This feller buncher has a Cummins 4BT engine. According to owner, the engine starts & runs good, has strong hydraulics and cylinders, a new tilt cylinder, and the shear is set up with electric over hydraulic controls. Planetary axle is in good order, hour meter reads 9,900 hours. 16" Clark shear head with new knives; grab arms are in good working condition and tracks are newer. New 19.5 14 ply tires. Machine has heat and Lexan door. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Bobcat 1080C 1987
$18,900
CAT 511 Feller Buncher with a 2010 Quadco Head

CAT 511 Feller Buncher with a 2010 Quadco Head

2010 CAT 511 Feller Buncher with a 2010 Quadco Head. This equipment has a C9 CAT engine, hour meter reads 7,800 hours, clean machine. New rotating motors in head, new teeth and holders, repacked closing and accumulator cylinders. New injectors approximately 1,000 hours ago (done by Ziegler CAT). New water pump 200 hours ago. Newer Jib cylinder. 35-1/2" pads on machine (comes with an extra set of 24" high grouser rails) Webasto pre heater, heat, A/C, and LED lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

CAT 511 Unknown
$134,900
Morbark Wolverine 3 Wheeled Feller Buncher

Morbark Wolverine 3 Wheeled Feller Buncher

1996 Morbark Wolverine 3 Wheel Cutter. This machine has a Perkins engine, runs and starts good, hour meter reads 4,645 hours, strong drive motors, lever controls for bunching head & foot petals for driving, strong hydraulics and cylinders, 2 new 30.5x32 tires with chains, straight disc, new teeth, Red Dot A/C may need a charge, heat, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Canada.

Morbark Wolverine 1996
$27,500
2001 Timberjack 608L Feller Buncher

2001 Timberjack 608L Feller Buncher

608L with Koehring side pocket hot saw, heat and that works, satellite radio! Recent rotary manifold, idlers, rollers and finals, spare head available. Ready to work. Call 406 544 7213

- - Unknown
$70,000
Valmet 430FXL Feller Buncher

Valmet 430FXL Feller Buncher

2009 Valmet 430FXL Feller Buncher. This equipment has a Cummins 8.3 engine, starts & runs good, has engine plug in, 11,500 hours, strong hydraulics and cylinders. Updated undercarriage, new rails, sprockets, and idlers 1500 hours ago. 24" pads. 22" 360 degree head in good condition, straight disc, leveling system is in good working order, heat, A/C, lights and radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Valmet 430 FXL 2009
$129,000
Timbco 425C Feller Buncher

Timbco 425C Feller Buncher

1996 Timbco 425C Feller Buncher with a Timbco Bar Saw Head. This equipment has a 8.3 Cummins engine, runs and starts good, strong hydraulics, has newer pumps. Undercarriage is @ 25%, 24" single grouser, strong boom, leveling system seeps over time, Timbco 30" bar saw head is in good order, also has accumulator, heat, A/C is not working. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Timbco 425C 1996
$36,900
Barko 775B Feller Buncher

Barko 775B Feller Buncher

1994 Barko 775B Feller Buncher. This machine has a Cummins 8.3 engine, runs and starts good, under 9,000 hours, strong hydraulics, charge pump and hydrostatics have been gone through, few leaks, decent center section, grab arms and accumulator arms have been re pinned and bushed recently. 22" head, straight disc good teeth. 28L x 26 tires @ 25%. Mono tracks and chains available. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Barko 775B 1994
$27,500
Timbco T445-C Feller Buncher ***SOLD***

Timbco T445-C Feller Buncher ***SOLD***

1998 Timbco T445-C Feller Buncher. This equipment has a Cummins 8.3 engine, runs and starts good, 11,400 hours, strong hydraulics and cylinders, Quadco 22B Head continuous rotation in good working order, straight disc has new teeth. Undercarriage is @ 75%, new sprockets 400 hours ago, 28" single grouser pads. Boom has been replaced, all pumps are in working order. Has a little play in one leveling shaft. Heat, A/C, & lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

Timbco T445-C 1998
$69,900
John Deere 653G Feller Buncher

John Deere 653G Feller Buncher

2003 John Deere 653G Feller Buncher. This buncher has a good running John Deere engine, strong hydraulics and drive system. good cylinders, hour meter reads 7,897 hours, tight pins and bushings on the boom and head, 36" pads. Head is a Waratah FS22 straight disc, new teeth, grab arms are in good condition. Heat, new A/C compressor and belt, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

John Deere 653G 2003
$62,000
Hydro Ax 470 Feller Buncher

Hydro Ax 470 Feller Buncher

2005 Hydro Ax 470 Feller Buncher. This machine has a Cummins engine, runs and starts good, new oil pan gasket, in-cooler, hydraulic cooler, new fan. Strong hydraulics and cylinders, joystick machine. 22" Head, 28Lx26 tires - 2 are new. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Hydro-Ax 470 2005
$40,000
Barko 775B Feller Buncher

Barko 775B Feller Buncher

1996 Barko 775B Feller Buncher. This machine has a 8.3 Cummins engine, runs and starts good. 22" head updated to Timbco Controls. Strong hydraulics, decent center section, 66x43x26 rubber, one extra tire on rim included. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Barko 775B 1996
$27,500