Sort By:   GridGallery
Photo Title
Make Model Year Price
Vermeer WC2300 Chipper

Vermeer WC2300 Chipper

2011 Vermeer WC2300 Chipper. This machine has a C13 440HP engine, runs and starts good, drum has been updated, air compressor, remote controlled, good condition, work ready. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Vermeer WC2300 2011
$Call for Price
2011 John Deere 843K wheeled feller Buncher

2011 John Deere 843K wheeled feller Buncher

2011 John deere 843K buncher 6500 hours F22D head 30.5x32 tires 70% joystick controls runs very well asking $92500.00 US

John Deere 843K 2011
$92,500
John Deere 548GIII Skidder

John Deere 548GIII Skidder

2011 John Deere 548GIII Grapple Skidder. Hour meter reads 3,872 hours, runs and starts good, strong hydraulics and cylinders, transmission is in good working order, tight center section, arch and grapple are in good condition, tires are @ 60%, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

John Deere 548GIII 2011
$146,000
Prentice 2570 Feller Buncher

Prentice 2570 Feller Buncher

2011 Prentice 2570 Feller Buncher with Center Post Head. This equipment has 7,700 hours, Cummins engine, runs and starts good, strong hydraulics and cylinders, saw pump has been replaced, tight center section, head and grab arms are all in good order, tight joystick controls, 28Lx26 tires @ 50% or better, heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA.

Prentice 2570 2011
$47,900
Morbark 2755 Flail Chipper

Morbark 2755 Flail Chipper

2011 Morbark 2755 Flail Chipper. This machine has 10,500 hours, CAT C27 tier II 875 HP main engine, twin disc hydraulics wet clutch, CAT 440 HP tier III C13 flail drive engine with triple gear box 1: 1 reduction gear box, they run and starts good, 27"x 55" infeed opening, feed roller is in good order. Discharge system consisting 60-1/2" wide x23' long telescoping drag chain conveyor drive, 7/8 chips, hydraulic tilt down cab for transport, Mor-lift 500 knuckleboom loader, joystick control, Rotobec 442 grapple, 3 knife disc, heat, A/C, and emergency shut down system. Re-worked flail pumps and rebuilt gear box for flail pumps 11/16. New bottom flail 11/16. New face plate and pocket holders on disk, injectors re-sealed. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located Southcentral USA.

Morbark 2755 2011
$349,000
CAT 535C Skidder

CAT 535C Skidder

2011 Caterpillar 535C Dual Arch Grapple Skidder with Winch. Hour meter reads 10,070 hours, runs and starts good, transmission is in good order, tight controls, strong hydraulics and cylinders, tight center section, arch was repined 2 years ago, 35.5x32 tires @ 40%, will need 1 tire soon, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA.

CAT 535C 2011
$96,500
Kobelco 260 Harvester with Logmax 7000XT Head

Kobelco 260 Harvester with Logmax 7000XT Head

2011 Kobelco 260 Harvester with a 2008 Logmax 7000XT Head. This machine runs and starts good, Cummins 6.7L engine, 4,300 hours on machine, 12,000 hours on head - has been gone through, strong hydraulics, tight boom, new Rotobec rotator on head, head has newer feed motor, new saw motor, repacked cylinders, Motomit computer in good order, new chains and sprockets, 24" pads, heat, A/C,and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada.

Kobelco 260 2011
$135,900
John Deere 1510E Forwarder

John Deere 1510E Forwarder

2011 John Deere 1510E Double Bunk 8 Wheel Forwarder. This machine has a good running engine, pre-heater, strong hydraulics, pumps were tested and are all in good order, tight boom and grapple, newer center section, new bearings in the rotating cab, tight boom and grapple, bogies are in good order, 710 tires @ 50% with a set of tracks, heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada.

John Deere 1510E 2011
$127,900
John Deere 643K Feller Buncher

John Deere 643K Feller Buncher

2011 John Deere 643K Feller Buncher. This machine has 5,800 hours, strong hydraulics, new center section, new saw deck, new set of teeth, tires are in good working condition, has extra set available, good glass, heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA.

John Deere 643K 2011
$62,500
John Deere 1210E Forwarder

John Deere 1210E Forwarder

2011 John Deere 1210E 8 Wheel Double Bunk Forwarder. This machine has 7,000 hours, runs and starts good, pre-heat system, strong hydraulics, new pump, new overhead cylinder, rotating and leveling systems are in good working order, tight boom and grapple, tight center section, bogies and axles are in good working condition, tracks and chains. Heat, A/C, lights, and radio. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

John Deere 1210E 2011
$244,500
Vermeer WC2300 Chipper

Vermeer WC2300 Chipper

2011 Vermeer WC2300 Chipper. This chipper has a CAT 440 HP with 4,000 hours, runs and starts good, strong hydraulics, feed chain is in good working order, GVW 32,000 LBS. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Vermeer WC2300 2011
$Call for Price
2011 PRENTICE 2432 SKIDDER

2011 PRENTICE 2432 SKIDDER

2011 PRENTICE 2432 SKIDDER

Prentice 2432 2011
$50,000