1988 John Deere 440D $30,000 New Center upper and lower Steering cylnider repacked pins and bushing Front axle povit repinned and bushed Winch clutch piston band clynder repacked New hose through out center New drive shaft carrier bearing New injections and set motor valves New stainless steel muffler and exhaust Working parking brake Enclosed heated cab Lights 4 new Babac diamond chains Spare tire and rim Not one bent panel New electric fuel pump Full set of new filters spare All oils changed less than 100 hours 7 chockers

1988 CAT 518 Grapple Skidder with Winch. This machine runs and starts good, recent rebuilt transmission, strong hydraulics and cylinders, new valves, tight center section and Esco grapple, 28Lx26 tires - rear 80%, front 50%. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

1988 Clark 666GR Grapple Skidder with Winch. This machine has a Clark auto transmission, new torque converter and updated drive ring. 5.9 Cummins engine, runs and starts good. All steering cylinders were rebuilt and repacked. Center & cylinders have been done. Clark winch. Rear differential was gone through 100 hours ago. 30.5x32 tires with one set of chains, heat, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

1988 Clark Ranger F666 Cable Skidder with Clark Winch. This skidder has a Reman Cummins 5.9 engine, runs and starts good, 7,100 hours, strong hydraulics and cylinders, 3 speed Clark transmission is in good working order, new charge pump, tight center section, has extra pins and bushings to go with, new blade pins and bushings, W3 Clark winch with complete winch for spare, has spare rear differential. New alternator and batteries. Firestone Forestry Specials 23.1x26 tires 75% front, rear tires are @ 50%. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

1988 John Deere 490D Processor with a Fabtek Head. This equipment runs and starts good, strong hydraulics, few minor leaks, 24' pads, roller, sprocket, and chains are all in good order, new main pin and bushings, head is in working order. Contact Erik @ Red Pine Equipment 218-720-0933. Processor is located in Northeast USA.

1988-89 John Deere 643 Feller Buncher. This machine has a newer engine, around 1,500 hours, starts & runs good, strong hydraulics and cylinder, 20" saw head, disc is in working order, decent pins and bushings, 28Lx26 tires @ 50-60%. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.