Sort By:   GridGallery
Photo Title
Make Model Year Price
2008 Rottne H14 with 15,000 hours and an SP head

2008 Rottne H14 with 15,000 hours and an SP head

2008 Rottne H14 with 15,000 hours and a SP561 head. Nice machine for the year, in decent shape, ready to work and priced right.

Rottne H14 2008
$80,000
Morbark Beever M20R Whole Tree Chipper

Morbark Beever M20R Whole Tree Chipper

2008 Morbark Beever M20R Whole Tree Chipper. This equipment runs and starts good, 4,302 hours, strong hydraulics, hydraulic swivel discharge chute with chip deflectors, infeed rollers and chains are in good condition, feed wheel and knifes are in good working order. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Morbark Beever M20R 2008
$54,900
John Deere 648H Skidder

John Deere 648H Skidder

2008 John Deere 648H Dual Arch Grapple Skidder. This machine has about 2,500 hours on a rebuilt engine, strong hydraulics and transmission, tight center section, grapple and arch are tight, axles and cradles are all in good order, cylinders and hoses are in good working condition, 30.5 x 32 tires @ 50% with Bear claw chains. Heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

John Deere 648H 2008
$51,500
Peterson 4800E Flail Debarker

Peterson 4800E Flail Debarker

2008 Peterson 4800E Flail Debarker. This equipment has a CAT C-9 engine, runs and starts good. Hours are estimated @ 8,200 hours, recently full serviced, all filters, bark pusher, slides, batteries, repacked cylinders and lifts. Flails are in good working order, 23" diameter opening, remote control. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Peterson Pacific 4800E 2008
$109,500
Peterson 4800E Flail Debarker

Peterson 4800E Flail Debarker

2008 Peterson 4800E Flail Debarker. This equipment has a CAT C9 engine, runs and starts good, 6,670 hours, strong hydraulics, drum is in good working order, new knives and chains. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***EQUIPMENT MUST MOVE, OPEN TO OFFERS***

Peterson Pacific 4800E 2008
$Call for Price
John Deere 1110D Forwarder ***ON HOLD***

John Deere 1110D Forwarder ***ON HOLD***

2008 John Deere 1110D Double Bunk Forwarder. This machine starts & runs good, new engine replaced at 4,100 hours, machine has 14,500 hours and is running daily, New turbo 2,300 hours ago, new head and head gasket, pre-heater, new brakes and canisters, transfer case and rear end bearing 800 hours ago, new computer readout. Tight boom and grapple, bogies are in good order, 710 tires, heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***ON HOLD***

John Deere 1110D 2008
$144,500
Dynamic Model 585 23" Chipper

Dynamic Model 585 23" Chipper

2008 Dynamic Model 585 23" Chipper. Machine has a John Deere 500 HP. Fuel consumption ~8 gallons/hour. 30 ton chipping in 30-45 minutes depending on material. Chips tops very well with side feed rollers, 23" max capacity, 3 feed chains on feed bed, comes with remote control, chute is non-variable, always pointing 180 degrees from feed table. Grapple hook for moving with skidder, pintle hitch. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Dynamic 585 2008
$59,900
Ponsse Ergo Harvester with H7 Head

Ponsse Ergo Harvester with H7 Head

2008 Ponsse Ergo Harvester with H7 Head. This equipment has a Mercedes engine, runs and starts good, strong hydraulics and cylinders, new conical pins in the crane base and upper and lower in the pillar. 6/20/18 all new pressure hoses, case drain hose and steal lines inside the boom. All new inner and outer swing gear bolts. bogies are in good order. Computer was just cleaned out at Ponsse. 710 tires are good with 1 set of tracks. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Ponsse Ergo 2008
$180,000
John Deere 843J Feller Buncher

John Deere 843J Feller Buncher

2008 John Deere 843J Feller Buncher. Hour meter reads 7,500 hours, runs and starts good, strong hydraulics and pumps. Recent center pins, loader arm pins and bushings. Joy stick controls, saw head is converted to joystick control. Webasto pre heating system. New bearing in the disk 300 hours ago. FD 22B Head in good working order, heat, A/C, and lights. 67x34.00 Tires - front are @ 90%, rear tires are @ 50%. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

John Deere 843J 2008
$69,900
John Deere 1270D Harvester

John Deere 1270D Harvester

2008 John Deere 1270D Harvester. 11,000 hours. Recent new injectors in engine which runs and starts good. H480 head has been rebuilt. 2 outer drive motors and one inner motor were rebuilt recently. Espar engine, hydraulic, and cab preheat system, strong hydraulics and cylinders, reman work pump and drive pump in the last 500 hours, tight boom and center section, stick and lift cylinders redone, bogies are in good working order, solid rear ends, 700 tires @ 50% with rear tracks, one set of chains. Feed rollers and grab arms are in good condition, Timbermatic HHM 300 computer. Heat, A/C,and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

John Deere 1270D 2008
$144,900
Komatsu 220LC with Limmit 2100 Delimber

Komatsu 220LC with Limmit 2100 Delimber

2008 Komatsu 220LC with Limmit 2100 Delimber. This equipment has 9,700 hours, runs and starts good, Komatsu engine, strong hydraulics and cylinders, straight boom, delimber is in good working order, undercarriage is @ 50%, triple grousers, new feed roller motor, rollers and cable are in good order, 36" topping saw, extra saw and hoses few cylinders. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA.

Komatsu 220LC 2008
$134,500
Mobark 2355 Flail Total Chip Harvester

Mobark 2355 Flail Total Chip Harvester

2008 Mobark 2355 Flail Total Chip Harvester. This machine has 10,000 hours, 3412E CAT engine, runs and starts good, strong hydraulics, Morlift 500 loader, debarker is in good working order, discharge conveyor, tilt cab. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Canada.

Morbark 2355 2008
$199,500