Sort By:   GridGallery
Photo Title
Make Model Year Price
Rottne H21 with SP761 Processing Head

Rottne H21 with SP761 Processing Head

2018 Rottne H21 with SP761 Processing Head. Hour meter reads 5,050 hours. John Deere 6090 engine. 750 tires estimated at 75%, including two sets of tracks that are in good condition. Webasto preheat system for engine, cab, & hydraulics. HK250 crane with a squirt boom and SP761 processing head, feed wheels and measuring system are in good working order. A new, heavier duty rotator was recently installed. Leveling and swing cab. Heated seat with heat, A/C, & radio. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

Rottne H21 2018
$350,000
2010 TIGERCAT H822C

2010 TIGERCAT H822C

2010 TIGERCAT H822C TRACKED SAWHEAD 8.3 CUMMINS 5702 TIGERCAT HEAD

Tigercat H822C 2010
$189,000
2013 Tigercat H822C Processor

2013 Tigercat H822C Processor

2013 Tigercat H822C Processor With 575 Dangle Head Approx. 10,000 hours, Complete New Undercarriage 1 Owner, Very Clean $269,500.00

Tigercat H822C 2013
$269,500
Peterson HC5400 Horizontal Grinder

Peterson HC5400 Horizontal Grinder

1998 Peterson HC5400 Horizontal Grinder. Hour meter reads 3,400 original hours. CAT 3412E 1,000 HP engine. New clutch and wiring harness. Recently re-hardfaced and rebuilt head, new belt, banana bars, T-bar, & anvil. 5 full sets of screen choices, 2" to 8". The 5" set is brand new and most are 80%+. Many spare parts included. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Peterson Pacific HC5400 1998
$349,900
Precision Husky Chipper

Precision Husky Chipper

1992 Precision Husky Chipper. Hours are unknown. KT 600 HP engine starts and runs good. New batteries, oversized cables, master switch, oversized starter, pockets, knife clamps, and counter knives, digital volt meter, and re-cored radiator within the last year. New bearings in feed rear feed wheel, a few new sprockets, drive chains, drive motors for the top feed wheel, rebuilt injector pump, and new hydraulic pump belts within the last 8 months. Also has a new shaft and bearings on the bottom feed wheel. 23" throat. Will fill 42 ton in 30-40 minutes depending on the wood. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

Precision Husky 1992
$60,000
HAHN HSW 110B Self Propelled Harvester ***SOLD***

HAHN HSW 110B Self Propelled Harvester ***SOLD***

1993 HAHN HSW 110B Self Propelled Harvester. This equipment starts and runs good, no major oil leaks. This machine was rebuilt in 2004 with a new crate JD engine. list of repairs, rebuilt inside long stroke/delimber cylinder, new right top knife cylinder, rebuilt cab tilt cylinder, new alternator, replaced front tires. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located Northeast USA. ***SOLD***

Hahn HWS 110B 1993
$45,000
1998 Hyundai 200 Processor with Fabtek Dangle Head

1998 Hyundai 200 Processor with Fabtek Dangle Head

Great running machine ,Fabtek forestry package, High walker, forestry cab, 1 owner

Hyundai Hyundai 200 High Walker 1998
$Call for Price
Bandit Intimidator 15XP Chipper

Bandit Intimidator 15XP Chipper

2021 Bandit Intimidator 15XP Chipper. Hour meter reads 1,543 hours. Ford 6.2L 165 HP engine. 37" diameter drum, 2 knife split pocket 5/8" chip. Single axle allow for towing as non-CDL trailer. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA.

Bandit Intimidator 15XP 2021
$49,500
Daewoo LL220 with Propac 453 Delimber

Daewoo LL220 with Propac 453 Delimber

2000 Daewoo LL220 with Propac 453 Delimber. Hour meter reads 9,880 hours. New Daewoo engine and rotary motor for the hydraulics with less than 1,000 hours. 24" double grouser pads, undercarriage is estimated at 75%, new tracks pins & rollers, some new pads and hardware. Propac 453 delimber is in good condition, bushings were just replaced, boom is straight. Heat, A/C, lights. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA.

Daewoo LL220 2000
$34,500
Link Belt LS-2800 with a Limmitt 2000B Delimber ***SOLD***

Link Belt LS-2800 with a Limmitt 2000B Delimber ***SOLD***

1989 Link Belt LS-2800 with a 1997 Limmitt 2000B Delimber. Isuzu 6 cyl. engine, runs and starts good, newer injectors. Straight boom, rollers and cables all in good order. New relief valves on the rollers & a new barrel for one of the lift cylinders. Re-packed right hand roller cylinder, new rubber bumper. Radiator was just repaired and serviced, new windshield and some cab glass, new starter, temp gauge, & shutoff solenoid. Newer pump. Two new pressure relief valves. Heat in cab. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

Link Belt LS-2800 -
$21,500
Tigercat LX830 Feller Buncher ***PENDING***

Tigercat LX830 Feller Buncher ***PENDING***

2005 Tigercat LX830 Feller Buncher. Hour meter reads 12,656 hours. 360° rotating Tigercat 5702 head, teeth & disc are in good condition. New oil cooler and fuel pump. Brand new collector in 2023 from Tigercat. New pin in leveling system, brakes, front windshield, & skylight. Fire suppression system in working order. Newer undercarriage, rails, sprockets, & top sliders were done 1,000 hours ago. Heat, A/C, & radio. Dry machine that's ready to work. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southeast USA. ***PENDING***

Tigercat LX830 2005
$150,000
Tigercat LX830D Buncher with Tigercat 5702 Head

Tigercat LX830D Buncher with Tigercat 5702 Head

2016 Tigercat LX830D Feller Buncher with Tigercat 5702 Head. Hour meter reads 10,226 hours. 24" single grouser pads, undercarriage is estimated at 75%. Leveling system is in good working order. Webasto preheat system. Tigercat 5702 felling head is in good condition, disc and teeth are good. Heat, A/C, radio, & lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA.

Tigercat LX830D 2016
$269,500