All listings for: RedPineEquipment

1998 Timbco 415D Processor with a 2005 Rolly II Head. This machine has a Cummins engine, runs and starts good, has some blow by, spare Cummins 5.9 engine to go with the machine as well, strong hydraulics and drive system, new pump, cylinders are in good order, swing gear and swing motor are all in good working condition, undercarriage is @ 50% 24" pads double grouser, head was just gone through, newer Woodland IFM computer system, heat, A/C has a compressor. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

1987 John Deere 548D Grapple Skidder with Winch. This machine has a rebuilt engine, runs and starts good, 20 hours on new water pump, 1,000 hours on new turbo, rebuilt front cradle, 3/4 and 5/8 plate, newer charge pump. The rear end has been re-worked, tight center section, valve bank has been gone through, Nokian 23.1x26 tires @ 75%, strong Power Shift transmission, diff locks and brakes in good order, new filters. Block heater and oil pan heater with HD plug in under the dash. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

1997 John Deere 648G Single Arch Grapple Skidder with Winch. This equipment runs and starts good, new hydraulic pump, cradles and axles are in good order, strong cylinders, Power shift transmission in good working condition, will need center pins soon, strong winch, 3/4" mainline, 28Lx26 tires @ 40%. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Southeast USA. ***SOLD***

2001 Ponsse Caribou 8 Wheeled Double Bunk Forwarder. This machine has a 4cyl Mercedes engine, runs and starts good, 16,000 hours, strong hydraulics, new traction pump and transfer case, bogies in good working order, new joystick controls, tight boom and grapple, heat, A/C, lights, new tracks, and chains. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

2004 Timberjack 460D Single Arch Grapple Skidder with Winch. Hour meter reads 5,600 hours, engine has 1,100 hours, runs and starts good, strong hydraulics and hydrostatics, cylinders are in good order, one grapple cylinder has a leak - not bad, winch is in good working order - 7/8 cable, 30.5x321 tires, tires are @ front 25%, rear tires @ 60%, heat, A/C needs a hose and charge, center has a little play not bad, arch pins are good. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located Southeast USA. ***SOLD***

30' Spread Axle Short Wood Trailer with a Serco 8000 Loader. This is a custom made trailer, spread axle, air ride, air brakes, Serco is around a 2000 has a extended boom, continuous rotation grapple, decent brakes and tires, needs a little work. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***