All listings for: RedPineEquipment

1985 Tree Farmer C5D Grapple Skidder. This equipment has a Detroit 353 engine, runs and starts good, strong hydraulics and Direct Drive transmission, Esco grapple. Can Car winch, with drive shaft, detached right now. Decent center section, arch and grapple are in good order. 18.4 x 26 tires. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in Northcentral USA. ***SOLD***

2003 Rottne 5005 Processor with 2011 Maskiner SP 561 Processor Head. This equipment has a John Deere 6068 engine, runs and starts good, Webasto pre heater, 17,000 hours on Rottne. Each tire has an independent leveling system. 2011 Maskiner SP 561 head, Dasa 4 measuring system, super cut 100 cut system. Solid boom with spare New Pro link, good tires. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

2008 Morbark Beever M20R Whole Tree Chipper. This equipment runs and starts good, 4,302 hours, strong hydraulics, hydraulic swivel discharge chute with chip deflectors, infeed rollers and chains are in good condition, feed wheel and knifes are in good working order. Contact Aaron @ Red Pine Equipment 218-720-0933. Machine is located in Northeast USA. ***SOLD***

2000 John Deere 653G Harvester with a 4 Roller Head. Hour meter reads 17,100 hours, John Deere 6068 engine, runs and starts good, decent feed rollers and grab arms, has a few leaks, strong hydraulics and drive system, just went through the tilt cylinders, undercarriage is in good working order, tight boom, measuring system works as it should, head has a little play. Heat, A/C needs a charge, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southcentral USA. ***SOLD***

2002 John Deere 850C LT Series II Dozer. This dozer has a 6 cyl. John Deere engine, runs and starts good, hour meter reads 8,074 hours, has been well maintained, strong hydraulics and drive system, all cylinders are in good working order. Undercarriage is @ 60%, pads are 24" single grouser, EROPS, heat, A/C, and lights. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northcentral USA. ***SOLD***

2009 Valmet 430FXL Processor with a Rolly II Intermittent Head. This machine runs and starts good, strong hydraulics and pumps, tight pins and bushings in the boom and head. Undercarriage is in good working order, single grouser pads. Rolly II head works good. Good glass. Heat, A/C, and lights. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA. ***SOLD***